Lantech LGS-1104 User Manual

More documents

Recommendations

Info

• There are 16 VLAN entries per page among 16 pages. To search the specified VLAN, please type in the VLAN ID in the empty field beside the label of ‘Quick Search Vlan Entry, Vlan ID:’ and then press ‘Search’. VLAN Setting interface VLAN Port Setting Click VLAN Port Setting to bring up the configuration interface for adjusting the VID Setting. • PVID: Enter the Port VLAN ID. • Awareness: Enable the awareness so that ports will strip the VLAN tag from received frames and insert the tag (contains PVID) into transmitted frames. 16
Disable the awareness so that ports will not strip the tag from received frames or insert the tag in transmitted frames. • Frame Type: Set the outgoing frame. ‣ Tag: Outgoing frames with VLAN-Tagged. ‣ All: All type of frames. • Click Apply to have the configuration take effect. • Or, click Refresh to refresh the configuration to view the newest state. VLAN Port Setting interface Port Trunk Port trunk allows multiple links to be bundled together and act as a single physical link for increased throughput. It provides load balancing, and redundancy of links in a switched inter-network. Actually, the link does not have an inherent total bandwidth equal to the sum of its component physical links. Traffic in a trunk is distributed across an individual link within the trunk in a deterministic method that called a hash algorithm. Traffic pattern on the network 17
Page 1 and 2: Lantech LGS-1104 4 10/100/1000T + 1
Page 3 and 4: Content FCC Warning ...............
Page 5 and 6: Introduction The 4 10/100/1000T + 1
Page 7 and 8: Spanning Tree IEEE802.1w rapid span
Page 9 and 10: Rear Panel The rear panel consists
Page 11 and 12: Desktop Installation Set the switch
Page 13 and 14: Two 4 10/100/1000T + 1 Mini-GBIC We
Page 15 and 16: 4. Key in the default password as
Page 17 and 18: failure (The default IP is 192.168.
Page 19: Statistics-2 (Detailed) The followi
Page 23 and 24: • Click Apply to have the configu
Page 25 and 26: • Hello Time (1-10): The scale of
Page 27 and 28: 802.1X Configuration IEEE 802.1X is
Page 29 and 30: • Or, click Refresh to refresh th
Page 31 and 32: QoS DSCP Mapping interface • Afte
Page 33 and 34: • And then, press Upload to updat
Page 35 and 36: Troubleshooting This section is int
Page 37 and 38: Technical Specification This sectio
Page 39 and 40: Operating Humidity 10% to 90% (Non-
Page 41 and 42: Straight-through cable schematic Cr

Lantech LGS-1104 User Manual

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?