EM3800SXâ¢EM5000SXâ¢EM6500SX - Geotech Environmental ...

More documents

Recommendations

Info

Wheel Kit Installation 1. Apply grease to the axle shaft as shown below, and install the two wheels on the axle shaft using the washers and split pins. 2. Install the axle assembly on the generator using four 8 16 mm flange bolts and 8 mm flange nuts. 3. Install the two stands on the under frame using four 8 flange bolts. 16 mm TORQUE: 1722 lbf·ft (2429 N·m , 2.43.0 kgf·m) GENERATOR SIDE 816 mm FLANGE BOLT (4) LONGER 816 mm FLANGE BOLT (4) 20 mm WASHER (2) AXLE WHEEL (2) STAND (2) 4.030 mm COTTER PIN (2) 64 8 mm FLANGE NUT (4)
Hanger Kit Installation (optional) 1. Position the hanger at the generator’s balance point as shown below. 2. Fit the end tabs of the hanger through the bracket slots, and bolt the brackets to the hanger and tighten securely. TORQUE: 1722 lbf·ft (2429 N·m , 2.43.0 kgf·m) 816 mm FLANGE BOLT (4) HANGER HANGER BRACKET (2) 280 mm (11 in) HANGER GENERATOR SIDE 65
Page 1 and 2:
EM3800SX•EM5000SX•EM6500SX See
Page 3 and 4:
Congratulations on your selection o
Page 5 and 6:
CONTENTS GENERATOR SAFETY .........
Page 7 and 8:
GENERATOR SAFETY SAFETY LABEL LOCAT
Page 9 and 10:
Electric Shock Hazards The generato
Page 11 and 12:
TRANSPORT HANDLE FUEL TANK CAP FUEL
Page 13 and 14:
Fuel Valve Lever The fuel valve is
Page 15 and 16: DC Terminals The DC terminals may O
Page 17 and 18: AC Circuit Breaker The AC circuit b
Page 19 and 20: GENERATOR USE Connections to a Buil
Page 21 and 22: AC Operation 1. Start the engine (s
Page 23 and 24: Voltage Selector Switch The power a
Page 29 and 30: An overloaded DC circuit, excessive
Page 31 and 32: High Altitude Operation At high alt
Page 33 and 34: Refueling With the engine stopped,
Page 35 and 36: STARTING THE ENGINE/STOPPING THE EN
Page 37 and 38: MAINTENANCE The Importance of Maint
Page 39 and 40: Maintenance Schedule REGULAR SERVIC
Page 41 and 42: Air Cleaner Service A dirty air cle
Page 43 and 44: Spark Plug Service In order to serv
Page 45 and 46: Fuse Replacement If the fuse is blo
Page 47 and 48: Service according to the table belo
Page 49 and 50: Engine Oil 1. Change the engine oil
Page 51 and 52: TRANSPORTING When transporting the
Page 53 and 54: No electricity at the AC receptacle
Page 55 and 56: Problems That May Affect Emissions
Page 57 and 58: WIRING DIAGRAM EM3800SX 55
Page 59 and 60: SPECIFICATIONS Dimensions Model Typ
Page 61 and 62: Dimensions Model Type Description c
Page 63 and 64: Important Safety Precautions Make s
Page 65: Handle Installation Install the rig
Page 69 and 70: Remote Control Box PILOT LAMP START
Page 71 and 72: CABLE TIE STARTER SOLENOID STARTER
Page 73 and 74: BEFORE OPERATION Before using your
Page 75 and 76: Honda PUBLICATIONS Shop Manual This
Page 77 and 78: PRE-OPERATION CHECK ...............
Page 79: 00X31-Z21-6050 K2:EM5000SX
show all

EM3800SXâ¢EM5000SXâ¢EM6500SX - Geotech Environmental ...

Create successful ePaper yourself

Delete template?

Save as template?

EM3800SXâ¢EM5000SXâ¢EM6500SX - Geotech Environmental ...