SERVICE MANUAL - Encompass Imaging
SERVICE MANUAL - Encompass Imaging
SERVICE MANUAL - Encompass Imaging
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
[ Video Signal Section ]<br />
FLOW CHART NO.1<br />
The key operation is not functioning.<br />
Are the contact point and installation state of the key<br />
switches (SW104~SW109) normal?<br />
Yes<br />
When pressing each switches (SW104~SW109)<br />
do the voltage of Pin(29) of CN302 increase?<br />
Yes<br />
Replace Digital Main CBA Unit.<br />
FLOW CHART NO.2<br />
No operation is possible from the remote control unit.<br />
Operation is possible from the remote control unit.<br />
Is 3.3V voltage supplied to Pin(2) terminal of the<br />
remote control receiver (RS101)?<br />
Yes<br />
Is the "L" pulse sent out Pin(1) terminal of remote<br />
control receiver (RS101) when the infrared remote<br />
control is activated?<br />
Yes<br />
Is the "L" pulse supplied to Pin(25) of CN301?<br />
Yes<br />
Replace Digital Main CBA Unit.<br />
FLOW CHART NO.3<br />
Picture does not appear normally.(Video input)<br />
Are the video signal inputted to Pin(4) of CN302?<br />
Yes<br />
Replace Digital Main CBA Unit or LCD Module<br />
Assembly.<br />
No<br />
No<br />
No<br />
No<br />
No<br />
No<br />
Re-install the switches (SW104~SW109) correctly<br />
or replace the poor switch.<br />
Check the switches (SW104~SW109) and their<br />
periphery, and service it if defective.<br />
Check AL+3.3V line and service it if defective.<br />
Replace the remote control receiver(RS101)<br />
or the remote control unit.<br />
Check the line between Pin(1) terminal of remote<br />
control receiver(RS101) and Pin(25) of CN301,<br />
and service it if defective.<br />
Check the line between Pin(4) of CN302 and<br />
JK752, and service it if defective.<br />
8-5 A91N3TR