Cooper B-Line Seismic Restraints - Dixie Construction Products

TRAPEZE BRACING
TRAPEZE TRANSVERSE AND LONGITUDINAL BRACING (Figure 11)
B-Line Channel
Longitudinal Brace
(See page 11)
ATR
All Threaded Rod
(See Page 57)
Rod Stiffener
(See Pages 57 & 58)
B2400
Series
Pipe Straps
(See Page 71)
1 (Min.)
1
B-Line Channel -
Size as Required
(See Page 22 -
Table 4 & 4A For
Channel Load Data)
See Note 3b
on page 17
B2000 Series
Pipe Straps
(See Page 70)
B-Line Channel
Transverse Brace
(See page 11)
B335-2- 1 /2 Adjustable Hinge
Longitudinal Brace
Hex Nut &
(See Page 59)
Square Washer
(See Page 62)
Notes:
1). B335-2 adjustable hinges for longitudinal braces may be attached on either side adjacent
to the all thread rod, or attached to the all thread rod itself.
2). B335-2 adjustable hinges for transverse braces may be attached to the all thread rod.
3). Two B335-2 adjustable hinges may be attached to the strut trapeze using the same bolt
or all thread rod.
4). It is not necessary to install both transverse braces and longitudinal braces on the same trapeze
support. Either set of braces may be removed to form a longitudinal brace only or a transverse
brace only if desired.
5). Longitudinal braces, when needed, must be installed at both ends of trapeze.
6). The equipment shown on this trapeze support is generic in nature. Any number of pipes,
conduits, ductwork or cable tray may be supported following the system weight and support
spans listed in Appendix 2 - Table 2.
7). Torque all nuts per Note D, page 9.
8). Refer to note Q, page 10 for installations requiring insulated pipe.
COOPER B-Line
509 West Monroe Street
Highland, Illinois 62249
Phone: 800-851-7415
Fax: 618-654-1917
Date:
Page No.
Sheet Number:
Raafat S. Aboulhosn
Structural Engineer S 3913
6 - 2 - 06
20
of