Cooper B-Line Seismic Restraints - Dixie Construction Products
Cooper B-Line Seismic Restraints - Dixie Construction Products
Cooper B-Line Seismic Restraints - Dixie Construction Products
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
TRAPEZE BRACING<br />
TRAPEZE TRANSVERSE AND LONGITUDINAL BRACING (Figure 10)<br />
B335-2-Bolt Size<br />
Adjustable Hinge<br />
(See Page 59)<br />
B-<strong>Line</strong> Channel<br />
Longitudinal Brace<br />
(See page 11)<br />
ATR<br />
All Threaded Rod<br />
(See Page 57)<br />
Rod Stiffener<br />
(See Pages 57 & 58)<br />
B-<strong>Line</strong> Channel<br />
Transverse Brace<br />
(See page 11)<br />
Cable Tray<br />
1 (Min.)<br />
1<br />
B-<strong>Line</strong> Channel<br />
Transverse Brace<br />
(See page 11)<br />
B335-2- 1 /2 Adjustable Hinge<br />
Transverse Brace<br />
(See Page 59)<br />
B-<strong>Line</strong> Channel - Size as Required<br />
(See Page 22 - Table 4 & 4A For<br />
Channel Load Data)<br />
Notes:<br />
See Note 3b<br />
on page 17<br />
B2400 Series<br />
Pipe Straps<br />
(See Page 71)<br />
B335-2- 1 /2 Adjustable Hinge<br />
Longitudinal Brace<br />
Hex Nut &<br />
(See Page 59)<br />
Square Washer<br />
(See Page 62)<br />
B2000 Series Pipe Straps<br />
(See Page 70)<br />
1). B335-2 adjustable hinges for longitudinal braces may be attached on either side adjacent<br />
to the all thread rod, or attached to the all thread rod itself.<br />
2). B335-2 adjustable hinges for transverse braces may be attached to the all thread rod.<br />
3). Two B335-2 adjustable hinges may be attached to the strut trapeze using the same bolt<br />
or all thread rod.<br />
4). It is not necessary to install both transverse braces and longitudinal braces on the same trapeze<br />
support. Either set of braces may be removed to form a longitudinal brace only or a transverse<br />
brace only if desired.<br />
5). Longitudinal braces, when needed, must be installed at both ends of trapeze.<br />
6). The equipment shown on this trapeze support is generic in nature. Any number of pipes,<br />
conduits, ductwork or cable tray may be supported following the system weight and support<br />
spans listed in Appendix 2 - Table 1.<br />
7). Torque all nuts per Note D, page 9.<br />
8). Refer to note Q, page 10 for installations requiring insulated pipe.<br />
COOPER B-<strong>Line</strong><br />
509 West Monroe Street<br />
Highland, Illinois 62249<br />
Phone: 800-851-7415<br />
Fax: 618-654-1917<br />
Date:<br />
Page No.<br />
Sheet Number:<br />
6 - 2 - 06<br />
19<br />
of<br />
Raafat S. Aboulhosn<br />
Structural Engineer S 3913