TL-WR542G 54M Wireless Router - TP-Link

More documents

Recommendations

Info

‣ LAN 1,2,3,4: ‣ WAN: Four 10/100Mbps RJ45 LAN ports for connecting the router to the local PC(s) This WAN port is where you will connect the cable/DSL Modem, or Ethernet ‣ Reset button: There are two ways to reset the router's factory defaults: 1) Use the Factory Defaults function on System Tools -> Factory Defaults page in the router's Web-based Utility. 2) Use the Factory Default Reset button: With the router powered on, use a pin to press and hold the Reset button(about 5 seconds) until the SYS LED becomes quick-flash from slow-flash. And then release the button and wait the router to reboot to its factory default settings. Note: Ensure the router is powered on before it restarts completely. ‣ Wireless antenna Figure 1-2 Rear Panel sketch 5
Chapter 2. Connecting the Router 2.1 System Requirements ‣ Broadband Internet Access Service (DSL/Cable/Ethernet) ‣ One DSL/Cable modem that has an RJ45 connector (you do not need it if you connect the router to the Ethernet) ‣ Each PC in the LAN needs a working Ethernet Adapter and an Ethernet cable with RJ45 connectors ‣ TCP/IP protocol must be installed on each PC ‣ Web browser, such as Microsoft Internet Explorer 5.0 or later, Netscape Navigator 6.0 or later 2.2 Installation Environment Requirements ‣ Do not place in direct sunlight or near a heater or heating vent ‣ Do not cluttered or crowded. There should be at least 2 inches (5 cm) of clear space on all sides of the router ‣ Well ventilated (especially if it is in a closet) ‣ Operating temperature: 0 ℃ ~40 ℃ (32 ℉ ~104 ℉ ) ‣ Operating Humidity: 10%~90%RH, Non-condensing 2.3 Connecting the Router Before you install the router, you should connect your PC to the Internet through your broadband service successfully. If there is any problem, please contact your ISP. After that, please install the router according to the following steps. Don't forget to pull out the power plug and keep your hands dry. 1. Power off your PC, Cable/DSL Modem, and the router. 2. Locate an optimum location for the router. The best place is usually near the center of the area in which your PC will connect wirelessly. The place must accord with the Installation Environment Requirements. 3. Adjust the direction of the antenna. Normally, upright is a good direction. 4. Connect the PC(s) and each Switch/Hub in your LAN to the LAN Ports on the router, shown in Figure 2-1. (If you have the wireless NIC and want to use wireless function, you can skip this step.) 6
Page 1 and 2: TL-WR542G 54M Wireless Router Rev:
Page 3 and 4: FCC STATEMENT This equipment has be
Page 5 and 6: For the following equipment: TP-LIN
Page 7 and 8: 4.8 Security ......................
Page 9 and 10: Chapter 1. Introduction Thank you f
Page 11: Figure 1-1 Front Panel sketch Name
Page 15 and 16: Chapter 3. Quick Installation Guide
Page 17 and 18: If the router's IP address is 192.1
Page 19 and 20: Figure 3-8 Quick Setup - Static IP
Page 21 and 22: menus on the left of the Web-based
Page 23 and 24: 4.4 Network Figure 4-2 the Network
Page 25 and 26: If you get address and find error w
Page 27 and 28: Time-based Connecting function can
Page 29 and 30: Click Logout to end 802.1X authenti
Page 31 and 32: ‣ Connect Automatically - Connect
Page 33 and 34: Figure 4-12 PPTP Settings ‣ User
Page 35 and 36: Click Restore Factory MAC to restor
Page 37 and 38: Note Dialog Note: Limited by local
Page 39 and 40: format stands for any combination o
Page 41 and 42: ‣ Privilege - Select the privileg
Page 43 and 44: pull-down list, enter 2F34D20BE2E54
Page 45 and 46: ‣ Address Lease Time - The Addres
Page 47 and 48: 2. Modify the information. 3. Click
Page 49 and 50: 3. Click the Save button. Click the
Page 51 and 52: There are many popular applications
Page 53 and 54: 4.8 Security Figure 4-33 The Securi
Page 55 and 56: 1. Effective Time - Enter a range o
Page 57 and 58: to 17:05. 2. Domain Name - Type the
Page 59 and 60: To modify or delete an existing ent
Page 61 and 62: etween 5 ~ 3600 packets. When the c
Page 63 and 64:
Click the Enable All button to make
Page 65 and 66:
4.11.1 Binding Setting This page di
Page 67 and 68:
• MAC Address - The MAC address o
Page 69 and 70:
Figure 4-52 Oray.net DDNS Settings
Page 71 and 72:
There are nine submenus under the S
Page 73 and 74:
1. Do not turn off the router or pr
Page 75 and 76:
Figure 4-60 Password It is recommen
Page 77 and 78:
Figure 4-63 Statistics ‣ Current
Page 79 and 80:
Appendix A: FAQ 1. How do I configu
Page 81 and 82:
Figure A-5 Add or Modify a Virtual
Page 83 and 84:
3) Make sure the wireless stations
Page 85 and 86:
Figure 0-2 5) The following TCP/IP
Page 87 and 88:
Now: Click OK to keep your settings
Page 89 and 90:
Appendix D: Glossary ‣ 2x to 3x e
show all

TL-WR542G 54M Wireless Router - TP-Link

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?