Smiths H-1000 Fluid Warmer Service Manual - internetMED

More documents

Recommendations

Info

International Symbols CIRCULATING WATER BATH TEMPERATURE Displays temperature of the circulating water bath in °C. This is not the temperature of the fluid delivered to the patient. SYSTEM OPERATIONAL This GREEN indicator illuminates when the power switch is ON and the heat exchanger has been properly installed. CHECK DISPOSABLES This Yellow indicator and pulsing AUDIBLE ALARM indicate the heat exchanger is NOT properly installed. There is also a RED indicator next to the top socket that illuminates if the #2 socket is not seated properly. ADD WATER This Yellow indicator and pulsing AUDIBLE ALARM indicate additional distilled water must be added to the water reservoir. WATER OVER TEMPERATURE This RED indicator and AUDIBLE ALARM indicate an over temperature condition. Press and hold this switch to confirm proper operation of the OVER TEMP circuitry. ALARM TEST Press and hold this button to confirm proper operation of alarm systems. When the switch is released, the OVER TEMP will continue to sound. This is normal operation. To clear the alarm condition, turn the unit off and then back on. OFF Only for a part of EQUIPMENT, Mains are still connected ON Only for a part of EQUIPMENT, Mains are connected Earth Potential IPX1 Protected against dripping water Type BF Equipotentiality This symbol is located next to the ground stud on the back of the unit 28
Attention, consult accompanying documents. Collect separately for electrical and electronic equipment. NOTES: 29
Page 1: OPERATOR’S AND SERVICE MANUAL - L
Page 4 and 5: About This Manual These instruction
Page 6 and 7: can be easily changed without patie
Page 8 and 9: CAUTION: This device must be assemb
Page 10 and 11: 3. CHECK DISPOSABLES This Yellow in
Page 12 and 13: 2. Secure the H-2 in place by tight
Page 14 and 15: NOTE: Chamber pressure must be rele
Page 16 and 17: ! WARNING ! Replacement filter with
Page 18 and 19: Trouble Shooting Slow Flow Rates Ma
Page 20 and 21: Water Over Temperature Alarm Press
Page 22 and 23: Ground continuity The H-1000 must b
Page 24 and 25: EVERY 12 MONTHS: 1. REPLACE O-RINGS
Page 26 and 27: NOTE: Please write the RGA# on the
Page 28 and 29: Electrical Parts List Schematic Sym

Smiths H-1000 Fluid Warmer Service Manual - internetMED

Create successful ePaper yourself

Delete template?

Save as template?