DH6/10

Sandwich valve
As the mounting dimension of the sandwich valve matches that of the solenoid
operated directional valve, the hydraulic circuit can be configured only by inserting it
between the solenoid operated directional valve and the manifold or the sub-plate.
Check valve S-(2)C
4-2
Pilot operated check valve S-(2)CH
4-5
Relief valve S-(2)RB
4-9
Sequence valve – Direct operated S-SD
4-12
Pressure reducing valve – Direct operated S-PRD
4-16
Throttle valve S-(2)T
4-20
Slow return check valve S-(2)TC
4-26
Check valve block S-4C
4-33
Check valve block ZA
4-36
Shock damping valve ZNS
4-39
(Note) The mounting bolt dimension of the solenoid operated directional valve manufactured
by us is as shown in the table below.
Valve type Mounting bolt dimension Tightening torque Nm (kgfcm)
Page
DE6(20, 30 series)
DE10(20 series)
M5-45*
6.4 ± 0.5(65 ± 5)
M6-35* 13 ± 1 (133 ± 10)
*The mounting bolt dimension in the case of 10 Series is as shown in the table below.
Valve type Mounting bolt dimension Tightening torque Nm (kgfcm)
DE6(10 series)
M5-50 7.4 ± 0.5 (75 ± 5)
DE10(10 series) M6-50 11.8 ± 1.7 (120 ± 18)
In the type selection, we recommend the one indicated
in color letters in the type indication explanation.
4-1