GM 300 MQL - Guhring

mQL TEcHNoLoGy
Introduction
Alongside the machine and tooling the costs for coolant are
a considerable portion of the overall cost of the machining
process. therefore, a reduction in the cooling lubrication
requirements offers a potential for cost savings.
the reduction of cooling lubricants is not only cost saving but
is also of benefit to the environment and health protection.
guhring is one of the pioneers in the research and development
of MQL that began in the mid 1990’s.
portion of costs
conventional
cooling
portion of
costs tools
other costs
(machines,
personnel etc.)
The aim of MQL machining
the acquisition of a new MQL cooling lubricant system
is significantly less expensive than conventional cooling!
• reduction of thermal stresses at the tool point
• less tool wear
• effective chip evacuation from deep holes
• reduction of cooling lubricant requirement
• high cooling and lubrication effect especially in deep holes
• lowering the resulting costs such as:
- component cleaning costs
- cooling lubricant disposal costs
- swarf disposal costs
• environment and health protection
portion of cost
MQL cooling
other costs
(machines,
personnel etc.)
saving potential
MQL machining
portion of
cost tools
MQL
49