GM 300 MQL - Guhring
GM 300 MQL - Guhring GM 300 MQL - Guhring
TEcHNIcAL INfoRmATIoN
mQL TEcHNoLoGy Introduction Alongside the machine and tooling the costs for coolant are a considerable portion of the overall cost of the machining process. therefore, a reduction in the cooling lubrication requirements offers a potential for cost savings. the reduction of cooling lubricants is not only cost saving but is also of benefit to the environment and health protection. guhring is one of the pioneers in the research and development of MQL that began in the mid 1990’s. portion of costs conventional cooling portion of costs tools other costs (machines, personnel etc.) The aim of MQL machining the acquisition of a new MQL cooling lubricant system is significantly less expensive than conventional cooling! • reduction of thermal stresses at the tool point • less tool wear • effective chip evacuation from deep holes • reduction of cooling lubricant requirement • high cooling and lubrication effect especially in deep holes • lowering the resulting costs such as: - component cleaning costs - cooling lubricant disposal costs - swarf disposal costs • environment and health protection portion of cost MQL cooling other costs (machines, personnel etc.) saving potential MQL machining portion of cost tools MQL 49
- Page 1 and 2: MQL BY GUHRING GM300 | MQL-Program
- Page 3 and 4: As one of the pioneers of MQL techn
- Page 5 and 6: MQL SySte teM finder HsK-A for auto
- Page 7 and 8: the minimal quantity lubrication MQ
- Page 9 and 10: mQL 1-channel-hydraulic chucks Hsk-
- Page 11 and 12: mQL 1-channel shrink fit chucks Hsk
- Page 13 and 14: mQL 1-channel shrink fit chucks Hsk
- Page 15 and 16: sealing lips for mQL 1-channel leng
- Page 17 and 18: mounting adaptor for mQL Hsk-A cool
- Page 19 and 20: mQL Hsk-A synchro tapping chucks fo
- Page 21 and 22: mQL 2-channel hydraulic chucks Hsk-
- Page 23 and 24: mQL 2-channel hydraulic chucks Hsk-
- Page 25 and 26: mQL 2-channel shrink fit chucks Hsk
- Page 27 and 28: mQL 2-channel shrink fit chucks Hsk
- Page 29 and 30: mQL 2-channel shrink fit chucks Hsk
- Page 31 and 32: mQL 2-channel length setting screws
- Page 33 and 34: mQL 2-channel coolant delivery set
- Page 35 and 36: mQL Hsk-A synchro tapping chucks fo
- Page 37 and 38: HSK Hsk cLAmPING TEcHNoLoGy BY GÜH
- Page 39 and 40: Suitable for different Spindle cont
- Page 41 and 42: 4-point clamping technology for mQL
- Page 43 and 44: GÜHRocLAmP mQL 4-point clamping se
- Page 45 and 46: Retention screw for GÜHRocLAmP mQL
- Page 47: mQL-cHEck 3000 PRoVIdEs AN oVERVIEW
- Page 51 and 52: mQL TEcHNoLoGy Optimally formed sha
- Page 53 and 54: mQL TEcHNoLoGy MQL system types the
- Page 55 and 56: GUHRING No. INdEx Guhring no. Tool
TEcHNIcAL INfoRmATIoN