1998 S/N 21329 - Walker Mowers
1998 S/N 21329 - Walker Mowers
1998 S/N 21329 - Walker Mowers
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Maintenance Instructions<br />
ADJUSTMENTS<br />
ADJUSTMENTS<br />
DANGER<br />
If the engine must be running to perform<br />
a maintenance adjustment, keep hands,<br />
feet, and clothing from moving parts. DO<br />
NOT wear jewelry or loose clothing.<br />
Safety Switches<br />
There are three (3) safety interlock switches on the<br />
tractor. Use the panel nuts on the switch body to position<br />
the switch for proper activation of the switch.<br />
The adjustment procedure for each switch is:<br />
Seat Switch<br />
Adjust switch position in body panel to achieve a<br />
1/32 to 1/16 in. (.79 mm to 1.59 mm) air gap between<br />
the switch plunger and seat frame with no weight on<br />
the seat. Test for proper operation.<br />
FSC Neutral-Park Switch<br />
1. Place the FSC in NEUTRAL-PARK position.<br />
2. Adjust switch to the point where the starter engages<br />
when the ignition switch is turned to the<br />
start position.<br />
3. Adjust switch position forward an additional 1/2<br />
to 1 turn of the panel nuts.<br />
NOTE: If the switch cannot be adjusted forward<br />
enough to achieve proper function, it may be<br />
necessary to bend the switch mounting bracket<br />
slightly.<br />
PTO Switch<br />
With the PTO engaged, adjust switch to achieve a<br />
1/64 to 1/32 in. (.40 mm to .79 mm) gap (plunger extension)<br />
between the switch body and the actuator<br />
plate.<br />
Tail Wheel Bearing Preload<br />
Preload the tail wheel bearings by tightening the axle<br />
nut until the wheel begins to tighten as it turns (not<br />
spin freely), then loosen the nut 1/2 to 1 turn. The<br />
wheel should spin freely without excessive end play.<br />
Lock the axle nut with the set screw in the nut.<br />
73