1998 S/N 21329 - Walker Mowers

More documents

Recommendations

Info

Maintenance Instructions REPLACING/REPAIRING Jackshaft Drive Belt Engine PTO Belt GHS Blower Belt (GHS Model Only) Hydrostatic Ground Drive Belt Belt Locations 64
Maintenance Instructions REPLACING/REPAIRING Engine PTO Drive Belt (3 Groove Power Band) 1. To remove the engine PTO drive belt: a. Remove the jackshaft drive belt from its idler pulley (by pushing down on idler pulley) and let the belt drop down out of the way. NOTE: Step (a) is not essential to removing the PTO belt, but it makes more room to work with the PTO belt. b. Push the clutch idler pulley down (until the PTO belt tightener stop block contacts the frame) and then shift the belt off the idler pulley (to the inside). c. Raise the clutch lever (engage position) to lift the clutch idler away from the belt. d. Next remove the belt from the engine pulley and then the PTO drive pulley. 2. Install the PTO drive belt by reversing the removal procedure. IMPORTANT: Make sure the belt is installed inside the four (4) belt guide pins. Refer to ADJUSTMENTS of Blade Clutch (PTO) in this section to check and make the following adjustments: a. Clutch engagement for proper belt tension b. Clutch disengagement and brake action Pull UP to Engage PTO Belt Tightener Stop Block Clutch Linkage PTO Belt Tightener Arm Engine PTO Belt Belt Guide Blade Clutch Lever in the DOWN Position Engine Pulley Belt Guides (Bottom Guide Not Visible) Clutch Idler Pulley Belt Guide PTO Drive Pulley Engine PTO Drive Belt Removal 65
Page 1 and 2:
OWNER’S MANUAL Safety, Assembly,
Page 3 and 4:
Table of Contents General Informati
Page 5 and 6:
General Information HIGHLIGHTED INF
Page 7 and 8:
Specifications MODEL MT 20.0 HP MT
Page 9 and 10:
Specifications MODEL MT 20.0 HP MT
Page 11 and 12:
Component Identification NOTE: Cont
Page 13 and 14:
Component Identification Donaldson
Page 15 and 16:
Safety Instructions 6. Do not wear
Page 17 and 18: Safety Instructions 4. Perform only
Page 19 and 20: Safety Instructions SAFETY, CONTROL
Page 21 and 22: Assembly Instructions 3. After the
Page 23 and 24: Assembly Instructions NOTE: When in
Page 25 and 26: Assembly Instructions PREOPERATING
Page 27 and 28: Assembly Instructions CAUTION Do no
Page 29 and 30: Operating Instructions Steering Lev
Page 31 and 32: Operating Instructions The Forward
Page 33 and 34: Operating Instructions Hourmeter Th
Page 35 and 36: Operating Instructions IMPORTANT: M
Page 37 and 38: Operating Instructions IMPORTANT: D
Page 39 and 40: Operating Instructions RECOMMENDATI
Page 41 and 42: Operating Instructions GRASS HANDLI
Page 43 and 44: Operating Instructions Clogging Che
Page 45 and 46: Operating Instructions Dumping the
Page 47 and 48: Operating Instructions Grass Catche
Page 49 and 50: Maintenance Instructions KOHLER TIP
Page 51 and 52: Maintenance Instructions LUBRICATIO
Page 59 and 60: Maintenance Instructions CLEANING 1
Page 61 and 62: Maintenance Instructions CLEANING P
Page 63 and 64: Maintenance Instructions CLEANING N
Page 65 and 66: Maintenance Instructions CHECKING/S
Page 67: Maintenance Instructions CHECKING/S
Page 71 and 72: Maintenance Instructions REPLACING/
Page 77 and 78: Maintenance Instructions ADJUSTMENT
Page 87 and 88: Maintenance Instructions ELECTRICAL
Page 89 and 90: Operator’s Notes 85
Page 91 and 92: LIMITED WARRANTY FOR WALKER COMMERC
show all

1998 S/N 21329 - Walker Mowers

Create successful ePaper yourself

Delete template?

Save as template?