1998 S/N 21329 - Walker Mowers

More documents

Recommendations

Info

Operating Instructions Instrument Panel This illustration shows the configuration of the switches and indicators located on the instrument panel. Hourmeter Voltmeter Oil Pressure Warning Light Over Temperature Warning Light Ignition Switch Light Switch (Optional) Warning Horn Instrument Panel 28
Operating Instructions Hourmeter The hourmeter displays operating time accumulated while the ignition switch is in the ON position. Voltmeter The voltmeter displays battery and charging system voltage. An indication of low or high voltage (below 11.5 volts or above 15.5 volts) indicates an electrical system failure. The cause of the failure should be determined and corrected. Oil Pressure Warning Light The oil pressure warning light indicates that engine oil pressure is below the safe operating range [below 3 to 5 PSI (21 to 34 kPa)]. This light (and warning horn) will come on when the ignition is turned ON, but should go off after the engine is started. If the light fails to come on when the ignition switch is turned ON, it could indicate a burned out bulb. If the light comes on during engine operation, stop the engine immediately and correct the source of the problem before further engine operation. IMPORTANT: Continued operation of the engine with an illuminated oil pressure warning light MAY cause severe engine damage (if a low oil pressure condition exists). Ignition Switch The ignition switch is used to start and stop the engine. The switch has three positions: “O” is the OFF position, RUN is the position the key returns to after starting, and “S” is the START position. When starting the engine, turn the key clockwise to the “S” position. Do not hold the key in the “S” position longer than 10 seconds. If the engine does not start, return the key to the “O” position for at least 60 seconds before making a restart attempt. Prolonged cranking can damage the starter motor and shorten battery life. Release the key when the engine starts, and it will return to the “RUN” position. To stop the engine, rotate the key counterclockwise to the “O” position. OFF ON START Over Temperature Warning Light The over temperature warning light indicates that engine oil temperature and/or cylinder head temperature are above the safe operating limit and the engine is overheating [above 305° F (152° C) oil or 450° F (232° C) cylinder head]. If this light comes on, there may be a problem with: • Engine cooling system (material packed into cylinder head cooling fins, clogged air intake screen) • Low oil level in crankcase Stop the engine and correct the source of the problem before further operation. Ignition Switch Light Switch (For Optional Lights) Operates headlights (when installed). Warning Horn The warning horn sounds to alert the operator that an unsafe engine condition is being indicated - when engine temperature is too high or engine oil pressure is too low. If the horn sounds, check the indicator lights and correct the problem before further operation. IMPORTANT: Continued operation of the engine with an illuminated over temperature warning light MAY cause severe engine damage (if a high oil temperature or head temperature condition exists). 29
Page 1 and 2: OWNER’S MANUAL Safety, Assembly,
Page 3 and 4: Table of Contents General Informati
Page 5 and 6: General Information HIGHLIGHTED INF
Page 7 and 8: Specifications MODEL MT 20.0 HP MT
Page 9 and 10: Specifications MODEL MT 20.0 HP MT
Page 11 and 12: Component Identification NOTE: Cont
Page 13 and 14: Component Identification Donaldson
Page 15 and 16: Safety Instructions 6. Do not wear
Page 17 and 18: Safety Instructions 4. Perform only
Page 19 and 20: Safety Instructions SAFETY, CONTROL
Page 21 and 22: Assembly Instructions 3. After the
Page 23 and 24: Assembly Instructions NOTE: When in
Page 25 and 26: Assembly Instructions PREOPERATING
Page 27 and 28: Assembly Instructions CAUTION Do no
Page 29 and 30: Operating Instructions Steering Lev
Page 31: Operating Instructions The Forward
Page 35 and 36: Operating Instructions IMPORTANT: M
Page 37 and 38: Operating Instructions IMPORTANT: D
Page 39 and 40: Operating Instructions RECOMMENDATI
Page 41 and 42: Operating Instructions GRASS HANDLI
Page 43 and 44: Operating Instructions Clogging Che
Page 45 and 46: Operating Instructions Dumping the
Page 47 and 48: Operating Instructions Grass Catche
Page 49 and 50: Maintenance Instructions KOHLER TIP
Page 51 and 52: Maintenance Instructions LUBRICATIO
Page 59 and 60: Maintenance Instructions CLEANING 1
Page 61 and 62: Maintenance Instructions CLEANING P
Page 63 and 64: Maintenance Instructions CLEANING N
Page 65 and 66: Maintenance Instructions CHECKING/S
Page 67 and 68: Maintenance Instructions CHECKING/S
Page 69 and 70: Maintenance Instructions REPLACING/
Page 77 and 78: Maintenance Instructions ADJUSTMENT
Page 83 and 84:
Maintenance Instructions ADJUSTMENT
Page 85 and 86:
Maintenance Instructions ADJUSTMENT
Page 87 and 88:
Maintenance Instructions ELECTRICAL
Page 89 and 90:
Operator’s Notes 85
Page 91 and 92:
LIMITED WARRANTY FOR WALKER COMMERC
show all

1998 S/N 21329 - Walker Mowers

Create successful ePaper yourself

Delete template?

Save as template?