KUKA Posiflex - KUKA Robotics

7 Transportation
7 Transportation
7.1 Transportation
Description
Move the positioner into its transport position each time it is transported. It
must be ensured that the positioner is stable while it is being transported. The
positioner must remain in its transport position until it has been fastened in position.
Before the positioner is lifted, it must be ensured that it is free from obstructions.
Remove all transport safeguards, such as nails and screws, in
advance. First remove any rust or glue on contact surfaces.
The center of gravity must be taken into account during transportation.
The positioner may tip during transportation. Risk of personal
injury and damage to property. The positioner must
be secured to prevent it from tipping.
Use of unsuitable handling equipment may result in damage
to the positioner. Only use handling equipment with
a sufficient load-bearing capacity. The positioner may only be transported in
the manner specified here.
There must be no fixtures and tools on the positioner during
transportation, as significant material damage could
otherwise result. The KUKA options (e.g. insulation, support strips) may remain
on the positioner during transportation.
Transport
position
The positioner must be in the transport position before it is transported, i.e. it
must not be tilted for transporting purposes.
Fig. 7-1: Transport position
Transport dimensions
The dimensions for the positioner can be noted from the following drawings.
The position of the center of gravity and the weight vary according to the specific
configuration. The specified dimensions refer to the positioner without
equipment.
Issued: 22.05.2012 Version: Spez KPF3-V2H V3 en
51 / 67