Enrange Flex Pro Flex M Pre-Engineered Radio Control ... - Magnetek

More documents

Recommendations

Info

10. RECEIVER CHANNEL CONFIGURATION SETTINGS (Bank 2 on RF/CPU Module) The channel can be set on the RF/CPU module via the Bank 2 dip switches. The following shows the channels or protocols available for each RF/CPU Module option. NOTE: See Section 7.2 for instructions on how to remove the CPU/RF module from the din rail and how to remove the PCB from the module housing. Flex PRO / Flex M Pre-Engineered Radio Control System Instruction Manual April 2012 Page 32 of 42
10.1. CHANNEL DIP SWITCH SETTINGS FOR 433MHz PART 15, version 2 RF/CPU MODULE (25-02- 074-816E) Flex PRO / Flex M Pre-Engineered Radio Control System Instruction Manual April 2012 Page 33 of 42
Page 1 and 2: Flex PRO / Flex M Pre-Engineered Ra
Page 3 and 4: 10. RECEIVER CHANNEL CONFIGURATION
Page 5 and 6: Your New Flex PRO/Flex M Radio Cont
Page 7 and 8: 2. RADIO CONTROLLED SAFETY 2.1. WAR
Page 9 and 10: 2.5. SAFETY INFORMATION AND RECOMME
Page 11 and 12: 2.8. BATTERIES WARNING KNOW AND FOL
Page 13 and 14: 3. GENERAL TRANSMITTER INFORMATION
Page 15 and 16: 3.3. TYPES OF BUTTONS The buttons u
Page 17 and 18: 4.2. INACTIVITY TIME OUT TIMER Bits
Page 19 and 20: 6. OPERATING PROCEDURE 6.1. GENERAL
Page 21 and 22: 7.1. MECHANICAL LAYOUTS 7.0 RECEIVE
Page 23 and 24: 7.2. RECEIVER INSTALLATION Figure 1
Page 25 and 26: 8. NORMAL OPERATION During the oper
Page 27 and 28: 9. FLEX MODULE TYPES The Flex M sys
Page 29 and 30: POWER SUPPLY MODULE OPTIONS Descrip
Page 31: Figure 27: Analog I/O Module Detail
Page 35 and 36: Flex PRO / Flex M Pre-Engineered Ra
Page 37 and 38: 11. TROUBLESHOOTING WARNING THE OPE
Page 39 and 40: 11.3. TROUBLESHOOTING TABLE Problem
Page 41 and 42: 11.4. ASSEMBLY AND REPLACEMENT PART

Enrange Flex Pro Flex M Pre-Engineered Radio Control ... - Magnetek

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?