Enrange Flex Pro Flex M Pre-Engineered Radio Control ... - Magnetek

More documents

Recommendations

Info

Additionally, there are 8 LEDs labeled 1 through 8 on the Analog I/O module. When the LED is on, this indicates that the module is sending/receiving a signal on that input or output. LED1 = Analog Output 1 is Active (non-zero) LED2 = Analog Output 2 is Active (non-zero) LED3 = Analog Output 3 is Active (non-zero) LED4 = Analog Output 4 is Active (non-zero) LED5 = Analog Input 1 is Active (non-zero) LED6 = Analog Input 2 is Active (non-zero) LED7 = Analog Input 3 is Active (non-zero) LED8 = Analog Input 4 is Active (non-zero) Flex PRO / Flex M Pre-Engineered Radio Control System Instruction Manual April 2012 Page 26 of 42
9. FLEX MODULE TYPES The Flex M system comprises of a RF/CPU module and a power supply module with application-specific add-on cards in-between the CPU module and power supply module. 9.1. FLEX RF/CPU MODULE The Flex RF/CPU Module is the main module that receives radio signals from a paired transmitter and interprets those signals into the appropriate response from the attached I/O modules. There is one RF/CPU module in the Flex M System. Figure 21: RF/CPU Module Detail View Bank 1 Dip 1 on the dipswitches is used to set the style of transmitter being used. See chart below for proper settings. BUTTON SETTING Dip-switch Setting 12-Button 1 8-Button 0 RF/CPU MODULE 433MHz Part 15, version 2 RF/CPU Module 25-02-074-816E Flex PRO / Flex M Pre-Engineered Radio Control System Instruction Manual April 2012 Page 27 of 42
Page 1 and 2: Flex PRO / Flex M Pre-Engineered Ra
Page 3 and 4: 10. RECEIVER CHANNEL CONFIGURATION
Page 5 and 6: Your New Flex PRO/Flex M Radio Cont
Page 7 and 8: 2. RADIO CONTROLLED SAFETY 2.1. WAR
Page 9 and 10: 2.5. SAFETY INFORMATION AND RECOMME
Page 11 and 12: 2.8. BATTERIES WARNING KNOW AND FOL
Page 13 and 14: 3. GENERAL TRANSMITTER INFORMATION
Page 15 and 16: 3.3. TYPES OF BUTTONS The buttons u
Page 17 and 18: 4.2. INACTIVITY TIME OUT TIMER Bits
Page 19 and 20: 6. OPERATING PROCEDURE 6.1. GENERAL
Page 21 and 22: 7.1. MECHANICAL LAYOUTS 7.0 RECEIVE
Page 23 and 24: 7.2. RECEIVER INSTALLATION Figure 1
Page 25: 8. NORMAL OPERATION During the oper
Page 29 and 30: POWER SUPPLY MODULE OPTIONS Descrip
Page 31 and 32: Figure 27: Analog I/O Module Detail
Page 33 and 34: 10.1. CHANNEL DIP SWITCH SETTINGS F
Page 35 and 36: Flex PRO / Flex M Pre-Engineered Ra
Page 37 and 38: 11. TROUBLESHOOTING WARNING THE OPE
Page 39 and 40: 11.3. TROUBLESHOOTING TABLE Problem
Page 41 and 42: 11.4. ASSEMBLY AND REPLACEMENT PART

Enrange Flex Pro Flex M Pre-Engineered Radio Control ... - Magnetek

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?