Enrange Flex Pro Flex M Pre-Engineered Radio Control ... - Magnetek

More documents

Recommendations

Info

3.2. INTERNAL ILLUSTRATION (PRO 12 CONFIGURATION) Figure 3 Figure 4 1. Encoder Board 6. I-CHIP 2. Aerial Antenna 7. Dip-Switch 3. Transmitting Module 8. Battery Contact Mechanism 4. Status LED Display 5. Function LED Displays NOTE: Flex PRO 8 Module will differ slightly Flex PRO / Flex M Pre-Engineered Radio Control System Instruction Manual April 2012 Page 14 of 42
3.3. TYPES OF BUTTONS The buttons used on the Flex Pro are fully proportional, stepless push buttons with an output that varies 0-100% (based on how far the button is depressed). Please consult the factory for more information. 3.4. ADJUSTABLE SPEED CONTROL The proportional buttons normally operate on a scale from 0-100%, but can also be scaled down to operate linearly from 0-25% over the full motion of the button. This gives the user more control over lower speeds. To adjust the speed control settings, press and hold the Start button, then press push button 1 or push button 2 to decrement/increment the range percentage. The red LEDs, which indicate the Speed Setting, will then change to reflect the current setting. Start + PB1 PB2 Speed control setting Decrement Speed Control Increment Speed Control Figure 5 Figure 6 Flex PRO / Flex M Pre-Engineered Radio Control System Instruction Manual April 2012 Page 15 of 42
Page 1 and 2: Flex PRO / Flex M Pre-Engineered Ra
Page 3 and 4: 10. RECEIVER CHANNEL CONFIGURATION
Page 5 and 6: Your New Flex PRO/Flex M Radio Cont
Page 7 and 8: 2. RADIO CONTROLLED SAFETY 2.1. WAR
Page 9 and 10: 2.5. SAFETY INFORMATION AND RECOMME
Page 11 and 12: 2.8. BATTERIES WARNING KNOW AND FOL
Page 13: 3. GENERAL TRANSMITTER INFORMATION
Page 17 and 18: 4.2. INACTIVITY TIME OUT TIMER Bits
Page 19 and 20: 6. OPERATING PROCEDURE 6.1. GENERAL
Page 21 and 22: 7.1. MECHANICAL LAYOUTS 7.0 RECEIVE
Page 23 and 24: 7.2. RECEIVER INSTALLATION Figure 1
Page 25 and 26: 8. NORMAL OPERATION During the oper
Page 27 and 28: 9. FLEX MODULE TYPES The Flex M sys
Page 29 and 30: POWER SUPPLY MODULE OPTIONS Descrip
Page 31 and 32: Figure 27: Analog I/O Module Detail
Page 33 and 34: 10.1. CHANNEL DIP SWITCH SETTINGS F
Page 35 and 36: Flex PRO / Flex M Pre-Engineered Ra
Page 37 and 38: 11. TROUBLESHOOTING WARNING THE OPE
Page 39 and 40: 11.3. TROUBLESHOOTING TABLE Problem
Page 41 and 42: 11.4. ASSEMBLY AND REPLACEMENT PART

Enrange Flex Pro Flex M Pre-Engineered Radio Control ... - Magnetek

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?