IntelliStation E Pro User Guide Professional ... - FTP Directory Listing

Ethernet Controller Messages
Note: The error messages shown in this section are available only with the
integrated Ethernet controller. These error messages are not available when
remote program load (RPL) or dynamic host configuration protocol (DHCP)
is used through optional network adapters.
If a failure condition occurs after the Ethernet controller is initialized, an error
message appears on the screen. The error messages that can occur are shown in the
following sections. If you experience any error related to the integrated Ethernet
controller, record the error message, and tell your network administrator about the
problem.
The two most common error messages are:
RPL-ROM-ERR: 1�5 The integrated Ethernet failed the loopback test.
RPL-ROM-ERR: 1�7 Media test failed; check the cable.
Error 105 indicates that a power-on diagnostic test performed by the Ethernet
module did not execute correctly. If this error message appears, you must have the
server serviced. Error 107 indicates that the cable from the LAN is not securely
connected to the Ethernet port on your server. Check the cable to ensure that it is
properly connected.
Appendix B. Ethernet Connector, Cable Specifications 147