02.11.2012 Views

IntelliStation E Pro User Guide Professional ... - FTP Directory Listing

IntelliStation E Pro User Guide Professional ... - FTP Directory Listing

IntelliStation E Pro User Guide Professional ... - FTP Directory Listing

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

POST Message Description<br />

20X A failure occurred during testing of the memory. This error can be caused<br />

by incorrectly installed memory, a failing DIMM, or a system-board failure.<br />

Action:<br />

1. If you have added memory, see “Memory DIMM Options” on page 85<br />

and Chapter 5, “Using the Configuration/Setup Utility <strong>Pro</strong>gram” on<br />

page 41 to verify that the new memory is correct for your computer,<br />

and that it is installed and configured correctly.<br />

2. Run the diagnostic programs to verify the problem. (See “IBM<br />

Enhanced Diagnostics” on page 126 for information about diagnostic<br />

programs provided with your computer.)<br />

If the problem cannot be isolated and corrected, have the computer<br />

serviced.<br />

301<br />

303<br />

A failure occurred during testing of the keyboard and keyboard controller.<br />

These error messages also might be accompanied by continuous beeping.<br />

Action:<br />

Ensure that:<br />

1. Nothing is resting on the keyboard and pressing a key.<br />

2. No key is stuck.<br />

3. The keyboard cable is securely attached to the keyboard connector on<br />

the computer. (For the location of the keyboard connector, refer to<br />

Chapter 2, “Setting Up Your Computer” on page 5.)<br />

Note: If you have just connected a new mouse or other pointing device,<br />

turn off the computer and disconnect that device. Wait at least 5<br />

seconds, and then turn on the computer. If the error message goes<br />

away, replace the device. If the error message remains, have the<br />

keyboard and cable or the computer serviced.<br />

601 A failure occurred during testing of the diskette drive and diskette-drive<br />

controller. This error can be caused by a loose or incorrectly connected<br />

cable, a failing drive, or a failing system board.<br />

Note: The computer can be used, but one or more diskette drives might<br />

not work.<br />

Action: Verify that all diskette drive cables are properly installed and<br />

securely connected.<br />

Running the diagnostic programs might isolate the diskette drive that<br />

failed, but you must have your computer serviced. (See “IBM Enhanced<br />

Diagnostics” on page 126 for information about diagnostic programs<br />

provided with your computer.)<br />

602 The computer is not able to start the diskette in the drive. The diskette<br />

might be damaged or formatted incorrectly.<br />

Action: Try another startable diskette that is formatted correctly and is in<br />

good condition. (For information and instructions on formatting diskettes,<br />

refer to Understanding Your <strong>IntelliStation</strong> E <strong>Pro</strong> and your operating-system<br />

documentation.)<br />

If this does not correct the problem, have the computer serviced.<br />

102 Using Your <strong>IntelliStation</strong> E <strong>Pro</strong>

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!