33 12 16.26 - 001-A - Response AAN-ANR Butterfly Valves - Garney ...

PF
DeviceNet Remote
Auxiliary Input (continued)
PP
DeviceNet Parity
57
4. Stop/Maintain Control
When energised this will make the Aux input Open/Close control push-to-run.
When de-energised, the Aux input Open/Close control will be maintained. ESD is
always push to run (non maintained).
5. Remote I/P Setting
Ensure that the correct “Od” setting is selected (refer to page 42).
For DeviceNet this is [OP].
The factory default for [PF] is [OF].
Examples
1. The full range of remote controls is needed. Open and Close are NO and ESD
and Stop/maintain is NC.
Aux I/P 4 3 2 1
Function 1 1 1 1 = F
Invert 0 0 1 1 = 3 i.e. set [PF] to [F3]
2. Open and close control is required along with 2 inverted digital signal inputs.
(Note that with this setting the open and close commands will be maintained.)
Aux I/P 4 3 2 1
Function 0 0 1 1 = 3
Invert 0 0 1 1 = 3 i.e. set [PF] to [33]
3. Only an ESD input is needed. The requirement is for push to run control with a
NO contact input.
Aux I/P 4 3 2 1
Function 1 1 0 0 = C
Invert 1 0 0 0 = 8 i.e. set [PF] to [C8]
Using the + or - keys display the
required mask setting.
PRESS THE
Auxiliary Input Mask OF
KEY.
The displayed option will flash
indicating that it has been set.
Press the ❖ key to display [PP].
This option is not used by the
DeviceNet DFU Module.
No Parity Bit
PRESS THE KEY.
The displayed option will flash
indicating that it has been set.