Animal identification Stock Breeding equipment Veterinary instruments

Heat detector, Insemination instruments, Ultrasound units,
Obstetric instruments
Spare parts for the calf puller
Spare ropes
for calf puller (46201, 46220, 46222)
46200.010
Holding bracket
for calf puller (46201)
46201.500
Grip complete
46200.080
Click plate
for models built 1995 and later
for models built before 1995
46200.090
46200.091
Spring and bolt
Winding ring
46200.095
46200.110
Support attachment
Complete thread pole
46200.120
46201.050
In many cases nowadays problems arise during calving, especially when cows have their first calving,
it could become necessary to give mechanical help. The calving aid can be used on laying cows as well
as on standing cows. Usually the natural calving process should be preferred. Only in case of problems
should the mechanical help be used.
At the end of the 180 cm long threaded bar is a rubber support part which is placed beneath the uterus
of the cow. The two calving ropes which are included are for looping the rope around each leg, the front
leg of the calf (if the calve is laying in opposite direction the rear legs). After this step the calving ropes
have to be hooked into the ratchet and the ratchet is moved by pulling the handle back and forward till
the ropes are tight. When the contractions have started, please assist during the contractions with careful
pulls of the ratchet, until the contraction is finished. Now wait for the next contraction. Because the legs
are looped in, the calf can not slip back into the uterus. It remains fixed in the pelvis due to the achieved
tension. At the next following contraction continue in the same way, until the calf is fully pulled out.
After the calving process is finished it is important to clean the calving aid carefully and thoroughly.
Please dry it afterwards and store it in dry condition.
79