Animal identification Stock Breeding equipment Veterinary instruments

Recommendations

Info

Clippers and Accessories, Hair scissors 128 Grinding outfits Grinding outfit (double sided) for blades for sheep, cattle, horses and dogs, high-performance motor, 230 volt, complete with 2 m lead, grinding disc 88193.010, wooden blade holder 88196.200 and 1 rod of emery, fine 88198 89251.000 Grinding outfit (one sided) for blades for sheep, cattle, horses and dogs, high-performance motor, 230 volt, complete with 2 m lead, schuko plug, grinding disc 88193.010, wooden blade holder 88196.200 and 1 rod of emery, fine 88198 89253.000 Motor for the grinding outfit single, 230 volt, 0,37 kW, 1.200-1.400 rotations/min 89250.210 Grinding disc for blades for sheep, cattle, horses and dogs, one sided, without grooves, 28 cm Ø, 19 mm bore diameter 88193.000 Grinding disc for blades for sheep, cattle, horses and dogs, double sided, without grooves, 28 cm Ø, 19 mm bore diameter 88193.010 Wooden blade holder for holding blades for cattle, horses and dogs during the grinding process 88196.200 Wooden blade holder for holding blades for sheep during the grinding process 88664.200 Emery rod following our approved Hauptner-Herberholz-composition fine, for regrind 88198.000 coarse, for pre-grinding 88199.000 Starting the grinding outfit First of all, please read the safety instructions carefully. Please fix the grinding unit on a desk with strong screws. After fixing thr grinding disc to the unit secure it with the screws included. Finally assemble the protection device above the grinding disc. Firstly bring some of the emery on to the wheel. Hold the emery rod on to the rotating wheel and move it so that the whole surface will be covered with emery. Before sharpening the blade fix the lower blade on to the wooden holder. Go parallel with the teeth showing to the earth on to the rotating wheel and move it back and forward from the outer edge of the wheel to the center, using the full surface. Move the blade in one straight line. It is necessary to grind as long as all blank parts on the lower blade have disappeared. The grinded side must show fine, symmetrical lines going from the back to the teeth. When the blade is ready, lift it carefully from the rotating wheel, by lifting firstly the teeth, so that the rotating wheel cannot damage the wheel. Now the same procedure has to be done with the upper blade. Please use the corresponding holder. The teeth must show to the bottom and use the full surface of the grinding disc going in one line back and forward.
Clippers and Accessories, Hair scissors <strong>Animal</strong> clipper <strong>Animal</strong> clipper PRO Series can be used with or without cord for maximum convenience Pro Series clipper with blade, 4 attachment combs (10, 13, 19 and 25 mm), oil, cleaning brush, scissors and instruction • cutting width approx. 46 mm • weight approx. 230 g • a fully charged clipper will deliver a minimum of 20 minutes of continuous trimming • input power (power supply) 230 volt, 50 Hz, 13 watt 88177.000 Optional accessory: Not included in delivery! Attachment combs 10 mm, cutting height 0,9 mm 88177.010 Attachment combs 13 mm, cutting height 2,0 mm 88177.020 Attachment combs 19 mm, cutting height 3,0 mm 88177.030 Attachment combs 25 mm, cutting height 5,0 mm 88177.040 129
Page 1:
Edition no. 5 Animal identification
Page 4 and 5:
Since 1857 we have been successfull
Page 6 and 7:
Concentrated competence for your ad
Page 8 and 9:
Diagnostic instruments 8 Thermomete
Page 10 and 11:
Diagnostic instruments Specula Spec
Page 12 and 13:
Surgical and anatomic instruments,
Page 14 and 15:
Page 16 and 17:
Page 18 and 19:
Page 20 and 21:
Page 22 and 23:
Page 24 and 25:
Page 26 and 27:
Page 28 and 29:
Page 30 and 31:
Page 32 and 33:
Page 34 and 35:
Page 36 and 37:
Page 38 and 39:
Page 40 and 41:
Syringes, Needles and Blood-taking
Page 42 and 43:
Page 44 and 45:
Page 46 and 47:
Page 48 and 49:
Page 50 and 51:
Page 52 and 53:
Page 54 and 55:
Page 56 and 57:
Page 58 and 59:
Page 60 and 61:
Heat detector, Insemination instrum
Page 62 and 63:
Page 64 and 65:
Page 66 and 67:
Page 68 and 69:
Page 70 and 71:
Page 72 and 73:
Page 74 and 75:
Page 76 and 77:
Page 78 and 79: Heat detector, Insemination instrum
Page 80 and 81: Heat detector, Insemination instrum
Page 82 and 83: Sexual organ instruments, Catheters
Page 92 and 93: Clinic equipment Examination and op
Page 94 and 95: Clinic equipment Trays and dishes I
Page 96 and 97: Clinic equipment Bandages Surgical
Page 98 and 99: Restraining equipment, Castration i
Page 122 and 123: Clippers and Accessories, Hair scis
Page 136 and 137: Livestock-Breeding equipment, Farm
Page 146 and 147: Brass ear tags, License plates, Ear
Page 148 and 149: Brass ear tags, License plates, Ear
Page 150 and 151: Marking hammers and Accessories Mar
Page 152 and 153: Tattooing pliers and Accessories, F
Page 158 and 159: Index A Air conditioned box for liq
Page 160 and 161: Index P Percussion hammers Pig hold
Page 162: Terms and Conditions of Delivery an
show all

Animal identification Stock Breeding equipment Veterinary instruments

Create successful ePaper yourself

Delete template?

Save as template?