Animal identification Stock Breeding equipment Veterinary instruments

Clippers and Accessories, Hair scissors
Electric 2000 PLUS - Horse clipper -
NEW:
best silent running (approx. 75 dB)
almost no vibration
optimised gear system
more cutting power
Good and approved:
• high-performance motor
• light weight, ca. 1025 g
• very handy because of ergonomic design
> Ø 51-53 mm thin
> 28,5 cm short
• one-hand operation
• overcharge switch
• top quality blades (can be resharpened very often!)
Horse clipper
with standard blades 86833 and 86872
cutting height 3 mm
Standard - upper blade 17 teeth, single
Standard - lower blade 28 teeth, single
89503.000
86833.000
86872.000
86833.000 86872.000
Post-clipping - upper blade 17 teeth, single
86833.000
Post-clipping - lower blade 35 teeth, single
86842.000
cutting height 3 mm
86833.000 86842.000
Adjustment of blades on the Electric 2000 PLUS - Cattle and horse clipper -
1) Remove the old blades by unfastening the regulating nut until the screw is screwable and easy to
pull out. Then remove the blades. Please pay attention to the regulating nut, that it does not loosen the
screw to avoid the loosing of single spare parts.
2) Take a brush for cleaning the clipping head carefully.
3) Adjust the eccentric block in such a way, so that it is possible to put in the guide of the upper blade
easily. Please make sure, that the surface of the blades is totally clean.
4) Put in the lower blade and adjust the screw, so that the screw can hold the blades.
5) Turn the regulating nut until you recognise the first resistance and afterwards again 1 1/4 of a turn
(Please see the marking on the regulating nut)
> The clipper is now ready to use! It is also important to oil the blades during the clipping process
several times in switched-on mode.
Each cattle and horse clipper, as well as sheep shearing machines are always delivered
complete including blades, oiler and instruction book in a strong carrying case.
123