Download complete user manual (PDF). - Brocade
Download complete user manual (PDF). - Brocade
Download complete user manual (PDF). - Brocade
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
PIM Dense 3<br />
Field<br />
DIT<br />
RegPkt<br />
AvgRate<br />
Profile<br />
Number of matching entries<br />
Outgoing interfaces Section<br />
L3<br />
L2<br />
HW<br />
SW<br />
Eth/Tr(VL1)<br />
Flags (explanation of flags in the<br />
OIF section)<br />
Src-VLAN<br />
Description<br />
Hardware Resource allocated for router receivers.<br />
Shows the number of packets forwarded due to the Register decapsulation.<br />
This field is displayed only on the active module. This field displays only those<br />
entries for which the device is the RP. However, for a PIM DM entry the RegPkt<br />
field is not displayed for the (S,G) entries on the active module.<br />
Shows the average rate of packets ingressing for this entry over a 30 second<br />
period. This field is displayed only on the active module for all entries that are<br />
hardware programmed (the fwd_fast flag is set on the active module).<br />
Shows the Profile ID associated with the Stream.<br />
Shows the total number of mcache entries matching a particular multicast<br />
filter specified.<br />
This section consists of three parts. L3 OIFs, L2OIFs and Blocked OIFs. And<br />
each section has Format of L3/L2/Blocked followed by (HW/SW) followed by<br />
count of the number of OIF in each section.<br />
Additionally, each section displays the OIFs one per line. And shows the OIF in<br />
the format eth/Tr(Vlan) followed by uptime/expiry time, followed by the Flags<br />
associated with each OIF.<br />
Shows whether the traffic is routed out of the interface.<br />
Shows whether the traffic is switched out of the interface.<br />
Shows whether the entry is hardware forwarded.<br />
Shows whether the entry is software forwarded.<br />
Shows the outgoing interface on the specified VLAN.<br />
Shows the flags set in each of the Outgoing interface in abbreviated string<br />
format whose explanations are as below. Legend of this shown at the top of<br />
each entry<br />
IM - Immediate<br />
IH - Inherited<br />
MJ - Membership Join<br />
MI - Membership Include<br />
ME - Membership Exclude<br />
BR - Blocked due to SG RPT<br />
BA - Blocked due to Assert<br />
BF - Blocked due to Filter<br />
BI - Blocked IIF (Incoming interface) matches OIF<br />
VLAN associated with the ingress interface.<br />
You can use the following command to filter the output to display only entries that egress port<br />
ethernet 1/1.<br />
<strong>Brocade</strong>#show ip pim mcache receiver ethernet 1/1<br />
You can use the following command to filter the output to display only the Source Specific Multicast<br />
(SSM) routes in the mcache.<br />
<strong>Brocade</strong>#show ip pim mcache ssm<br />
You can use the following command to filter the output to display only the Sparse Mode routes in<br />
the mcache.<br />
<strong>Brocade</strong>#show ip pim mcache sparse<br />
FastIron Ethernet Switch IP Multicast Configuration Guide 83<br />
53-1002638-02
Change language