Download complete user manual (PDF). - Brocade

1
PIM6 SM snooping show commands
Perform the following steps to enable PIM6 SM snooping globally.
1. Enable MLD snooping passive globally.
Brocade(config)#ipv6 multicast passive
2. Enable PIM6 SM snooping globally.
Brocade(config)#ipv6 pimsm-snooping
This command enables PIM6 SM traffic snooping. The PIM6 SM traffic snooping feature
assumes that the network has routers that are running PIM6 SM.
To disable PIM6 SM snooping, enter the no ipv6 pimsm-snooping command.
Brocade(config)#no ipv6 pimsm-snooping
If you also want to disable IP multicast traffic reduction, enter the no ipv6 multicast command.
Brocade(config)#no ipv6 multicast
Syntax: [no]ipv6 pimsm-snooping
Enabling PIM6 SM snooping on a VLAN
Perform the following steps to enable PIM6 SM snooping on a VLAN.
1. Configure a VLAN and add the ports that are connected to the device and host in the same
port-based VLAN.
Brocade(config)#vlan 20
Brocade(config-vlan-20)#untagged etherenet 1/1/5 ethernet 1/1/7 ethernet
1/1/11
2. Enable MLD snooping passive on the VLAN.
Brocade(config-vlan-20)#multicast6 passive
3. Enable PIM6 SM snooping on the VLAN.
Brocade(config-vlan-20)#multicast6 pimsm-snooping
Syntax: [no] multicast6 pimsm-snooping
Disabling PIM6 SM snooping on a VLAN
When PIM6 SM snooping is enabled globally, you can still disable it for a specific VLAN. For
example, the following commands disable PIM6 SM snooping for VLAN 20. This setting overrides
the global setting.
Brocade(config)#vlan 20
Brocade(config-vlan-20)#multicast6 disable-pimsm-snoop
Syntax: [no] multicast6 disable-pimsm-snoop
PIM6 SM snooping show commands
This section shows how to display information about PIM6 SM snooping, including:
24 FastIron Ethernet Switch IP Multicast Configuration Guide
53-1002638-02