Download complete user manual (PDF). - Brocade
Download complete user manual (PDF). - Brocade
Download complete user manual (PDF). - Brocade
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Clearing the PIM message counters 3<br />
-----+---------+---------+---------+---------+----------<br />
Rx Rx Rx Rx Rx<br />
-----+---------+---------+---------+---------+----------<br />
v30 0 0 0 0 0<br />
v50 1260 1260 0 1 1<br />
v150 0 0 0 0 0<br />
v200 0 0 0 0 0<br />
<strong>Brocade</strong>#show ip pim traffic join-prune tx<br />
Port Packet Join Prune Avg Aggr Last Aggr<br />
-----+---------+---------+---------+---------+----------<br />
Tx Tx Tx Tx Tx<br />
-----+---------+---------+---------+---------+----------<br />
v30 0 0 0 0 0<br />
v50 1264 1263 1 1 1<br />
v150 0 0 0 0 0<br />
v200 0 0 0 0 0<br />
Syntax: show ip pim [vrf vrf-name] traffic [join-prune | rx | tx]<br />
• vrf—PIM traffic statistics for the VRF instance identified by vrf-name<br />
• join-prune—Join/prune statistics.<br />
• rx—Received PIM traffic statistics.<br />
• tx—Transmitted PIM traffic statistics.<br />
NOTE<br />
If you have configured interfaces for standard PIM (dense mode) on the device, statistics for these<br />
interfaces are listed first by the display.<br />
Table 21 describes the output from this command.<br />
TABLE 21<br />
This field...<br />
Output from the show ip pim vrf traffic command<br />
Displays...<br />
Port<br />
Hello<br />
J or P<br />
Register<br />
RegStop<br />
Assert<br />
Total Recv or Xmit<br />
Total Discard or chksum<br />
The port or virtual interface on which the PIM interface is configured.<br />
The number of PIM Hello messages sent or received on the interface.<br />
The number of Join or Prune messages sent or received on the interface.<br />
NOTE: Unlike PIM dense, PIM Sparse uses the same messages for Joins and<br />
Prunes.<br />
The number of Register messages sent or received on the interface.<br />
The number of Register Stop messages sent or received on the interface.<br />
The number of Assert messages sent or received on the interface.<br />
The total number of IGMP messages sent and received by the device.<br />
The total number of IGMP messages discarded, including a separate counter for<br />
those that failed the checksum comparison.<br />
Clearing the PIM message counters<br />
You can clear the PIM message counters using the following command.<br />
FastIron Ethernet Switch IP Multicast Configuration Guide 109<br />
53-1002638-02