You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
LCDM61NF21(MT02+DE200) Factory Alignment Specification<br />
3.Alignment Procedure<br />
General Description<br />
LCD42/37M61NF21 is designed for Europe, using 37/42 inch Full HD<br />
panel. The main chip is MTK8206. Support 1x RF in, 0.5x SCART, 1XSCART,<br />
1xYPbPr, 1xVGA, 1xside AV include YC input, 2xHDMI,1x headphone out,<br />
1xDVB-T input. The detail please refer the SyRS�<br />
1�Main board alignment<br />
For Analog part<br />
Before power on, please check and make sure the output of U20�U21�<br />
U22�U23,U24�U30�U31 are not shorted to grand.<br />
Supply 5v to P504 and test the output of U20, the normal is 3.3V+/-5%, the<br />
U21 output should be 1.8V+/-5%<br />
Download the SW to the main chip, please see the chapter of how to<br />
download<br />
Check all the function of the all others board on the test tool<br />
For PCMCIA interface<br />
Digital module servicing and debug hints.<br />
Mainly point:<br />
1. Check PCB and each section power supply: 12V, 5V, 1.2V,1.8V ,3.3V.<br />
2. Switch on the power, then measure the signal of output port of video and<br />
audio.<br />
If no output, check the following point:<br />
1) video output of CPU section.<br />
2) 4Mhz clock of the tuner output<br />
3) Output of chip 74AHC1GU04( position U24 of schematic). 4Mhz clock<br />
signal<br />
to CUP(PNX8314).<br />
4) Signal of SDRAM and flash chip when working .<br />
5) Audio DAC ( component’s position U6 of schematic.<br />
By contraries, enter the menu’s manual research item, and set appointed<br />
channel number, check the signal indicator on TV screen.<br />
3. Normal there is a signal level display on the menu.<br />
If no displaying for the signal state indicated information, check the<br />
following point:<br />
1) 4Mhz clock signal of the tuner output,<br />
2) Output of chip 74AHC1GU04(component’s position U23 of<br />
schematic).<br />
3) Else channel decoder schematic section.<br />
4. When it display the signal state indicated information, Press “ok’ button,<br />
and research program. It will not play the program if not get the program