NZ4202 - Unitec

SNZ NZSw4202 95 m 8583169 0042484 45T m
Issued June 1995 NZS 4202: 1 995
6.3.2 Measurement procedure
The following shall be measured separately:
6.3.2.1
Foundations and footings, for each type.
6.3.2.2
Small bases, fence posts, shallow piles and the like, for each type. Where not
exceeding 0.2 m3 they shall be enumerated.
6.3.2.3
Machine bases and the like. The total number and the minimum and maximum sizes
shall be stated in the description.
6.3.2.4
Bedding to structural steel or metalwork shall be enumerated and the size stated.
6.3.2.5
Slabs, for each thickness. If finished to falls or crossfalls, this shall be stated and the
averagethickness given. The measurement shall betakenacross beams. Wherethe
slope exceeds 15 degrees, the angle of pitch shall be given.
6.3.2.6
Beams, lintels, columns and piers shall each be measured separately. The
measurement of beams and lintels shall exclude the thickness of the floor ortopping.
Columns and piers cast integrally with walls shall be measured with the wall and this
shall be stated in the description.
--`,,``,,,,,,``,``,`,,,`,,,`,-`-`,,`,,`,`,,`---
6.3.2.7
Walls, stating thickness.
6.3.2.8
Retaining walls, stating thickness.
6.3.2.9
Bands, cornices and projections where not integral with the surrounding concrete.
6.3.2.1 O
Steps and staircases including strings, soff its, balustrades and landings.
6.3.2.1 1
Channels, stating the shape, width, and average depth.
6.3.2.12
Upstands and kerbs. Where not exceeding 0.05 m2 in section they shall be
measured in metres including formwork.
6.3.2.13
Blinding concrete shall be measured in square metres with the thickness stated.
Copyright Standards New Zealand
Provided by IHS under license with SNZ
Document provided by IHS Licensee=Unitec Inst of Technology/5911177001,
03/02/2005 18:31:52 MST Questions or comments about this message: please call
the Document Policy Group at 303-397-2295.
6-2