TracVision M7 GyroTrac Configuration - Jamestown Distributors

More documents

Recommendations

Info

ADCU Flush Mounting Template .63" (16 mm) 1.83" (46 mm) 4x .136" (3.45 mm) 7.62" (194 mm) 3.08" (78 mm) .63" (16 mm) 8.87" (225 mm) 4x R .63" (16 mm) 51
KVH Industries, Inc. 50 Enterprise Center Middletown, RI 02842-5279 U.S.A. Phone: +1 401 847-3327 Fax: +1 401 849-0045 E-mail: info@kvh.com Internet: www.kvh.com KVH Europe A/S Kokkedal Industripark 2B 2980 Kokkedal Denmark Phone: +45 45 160 180 Fax: +45 45 160 181 E-mail: info@kvh.dk Internet: www.kvh.com © Copyright 2006 KVH Industries Inc. KVH and <strong>TracVision</strong> are registered trademarks of KVH Industries Inc.
Page 1 and 2: TracVision M7 GyroTrac Configurati
Page 3 and 4: TracVision M7 Installation Guide Gy
Page 5 and 6: 2 Plan the Antenna Installation Con
Page 7 and 8: 4 Plan the ADCU Installation Consid
Page 9 and 10: 6 Remove the Restraint Inside the a
Page 11 and 12: 8 Mount the Antenna Follow these st
Page 13 and 14: 9 Continued Mount the Sensor Option
Page 15 and 16: 10 Wire the Receiver(s) If you are
Page 17 and 18: 12 Connect Power Follow these steps
Page 19 and 20: 14 Select Satellites Follow these s
Page 21 and 22: 14 Select Satellites Follow these s
Page 23 and 24: 16 Get the LNB Skew Angle To optimi
Page 25 and 26: 18 Run Two Check Switch Tests If yo
Page 27 and 28: 19 Continued Calibrate the Sensor d
Page 29 and 30: Appendices This section provides su
Page 31 and 32: SATELLITE IN SATELLITE IN SATELLITE
Page 33 and 34: B Connecting a PC to the ADCU If yo
Page 35 and 36: D Connecting External Equipment In
Page 37 and 38: D Continued Connecting External Equ
Page 43 and 44: E Continued Entering Sensor Offset
Page 45 and 46: G Position Grids If the vessel is l
Page 47 and 48: H Wiring Diagrams ADCU Wiring - Opt
Page 49: H Wiring Diagrams Basic Wiring - Li

TracVision M7 GyroTrac Configuration - Jamestown Distributors

Create successful ePaper yourself

Delete template?

Save as template?