minutes board of supervisors, harrison county, mississippi minute ...

SMARTCODE
Harrison County, Mississippi
ARTICLE 5. BUILDING SCALE PLANS
5.1 INSTRUCTIOIIJS
5.1.1 The requirements described in this Article shall control the Disposition, Configuration
and Function of buildings, as well as their architectural, landscape, parking, signage,
ambient and visitability standards.
5,1,2 Building and Site Plans submitted under this Article shall show the following, in
compliance with the standards described in this Article:
a, For site approval process:
• Building Disposition
• Building Configuration
• BUilding Function
• Parking Standards
b, For building application process:
• Landscape Standards
• Signage Standards
• Ambient Standards
• Visitability Standards
• Special Requirements
5.2 SPECIFIC TO NATURAL AND RURAL TRANSECT ZONES (T1 & T2)
The following shall be applicable to Zones T1 and T2:
5,2,1 Buildings in the T1 and T2 Zones are permitted by Variance. Permission to build
in T1 and T2 and the standards for Disposition, Configuration, Function, parking,
environmental, ambient and visitability shall be determined concurrently as
Variances, in public hearing of the Planning Commission.
5.2.2 Environmental Standards:
The modification of the natural conditions shall be according to Local, State and
Federal guidelines.
5.3 SPECIFIC TO SUB-URBAN TRANSECT ZONE (T3)
5.3.1 Building Disposition (T3):
a. NeWly platted lots shall be dimensioned according to Table 13B.
b. Buildings shall be disposed in relation to the boundaries of their lots according to
Table 13B.
c. One Principal Building at the Frontage, and one Outbuilding to the rear of the
Principal Building, may be built on each lot as shown in Table 138.
d, Lot coverage by building shall not exceed that shown in Table 13B.
e. Facades shall be bUilt parallel to a rectilinear Principal Frontage Line or parallel
to the tangent of a curved Principal Frontage Line,
f, Setbacks for Principal BUildings shall be as shown in Table 13. In the case of an
Infilllo1, Setbacks shall match one or the other of the existing adjacent Setbacks.
Setbacks may otherwise be adjusted by Variance.
g, Rear Setbacks for Outbuildings shall be aminimum of 12 feet measured from the
centerline of the Alley or Rear Lane easement. In the absence of Rear Alley or
Lane, the rear Setback shall be as shown in Table 13B.
h. Building Types shall be as shown in Table 8.
5,3.2 Building Configuration (T3):
a. Private Frontage types shall conform to and be allocated in accordance with
SMARICODl VERSI"'I 9.0 17