ZonePRO Install Guide-English - dbx

Diagram A
Section 4
Zone Controllers
ZonePRO TM
Diagram A
Wiring In Series
To wire the Zone Controllers in series, daisy chain each ZC using the ports on each (see
Diagram B) then connect one of the ZCs to the appropriate ZC Input Port on the ZonePRO
device. It is not important which ZC port you use on each ZC or which ZC in the chain is
connected to the ZonePRO device.
Diagram B
ID# 1 ID# 4
80-1342-A
UL-6500
80-1342-A
UL-6500
IEC60065
IEC60065
RJ45
CONNECT ONLY TO
ZONE CONTROLLER
INPU T .
RJ45
CONNECT ONLY TO
ZONE CONTROLLER
INPU T .
RS-232
Diagram B
ID# 1 ID# 4
80-1342-A
UL-6500
80-1342-A
UL-6500
RS-232
Wiring In Parallel
To wire Diagram the Zone C Controllers in parallel, a ZC-BOB must be used. To wire in parallel, each
Zone Controller must be wired into one of the ZC-BOB’s numbered ports. The ZC BOB’s
Output port is then connected to one of the ZonePRO’s ZC Input ports (see Diagram C). For
troubleshooting purposes, it is recommended to match the numbered ports on the ZC-BOB
with the corresponding DIP switch assignments on each ZC (for example, ID#6 or ID#12 would
RS-232
be connected to the #6 port on the ZC-BOB).
RJ45
CONNECT ONLY TO
ZONE CONTROLLER
INPU T .
IEC60065
RJ45
CONNECT ONLY TO
ZONE CONTROLLER
INPU T .
IEC60065
Diagram C
RS-232
Each ZonePRO device can accommodate up to two ZC-BOBs. Daisy chaining ZCs off the
ZC-BOB is not supported!
16