Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
• Lay the Perimeter Wire from the Perimeter Switch to the<br />
lawn.<br />
2 wires under the<br />
same peg<br />
• Start laying the wire in anticlockwise direction.<br />
• Once completing the Perimeter Wire loop, lay the wire back<br />
towards the Perimeter Switch.<br />
• At the end of the Perimeter Wire loop, you have now<br />
two wires. Lay the two loose wires in the direction of the<br />
Perimeter Switch location and peg them to the ground using<br />
a single peg for both.<br />
4.8.4 At the Perimeter Switch’s location:<br />
• Trim the ends of the loose wire to equal length and twist<br />
them together.<br />
• Strip 5mm (0.2 inches) of insulation from the wire without<br />
the plot connector.<br />
• Insert this wire end into the free hole in the connector and<br />
tighten the screws.<br />
Small flat screwdriver<br />
• Plug the perimeter wire connector into the Perimeter Switch.<br />
25