ROBOMOW robotic mower manual

• If the working area borders against a flat path
that lies level with the lawn, it is possible to allow
Robomow to run over the path. The Perimeter Wire
should then be laid 10 cm (4 inches) from the edge
of the path.
• When the working area is divided by a flat path
that is level with the lawn, it is possible to allow
Robomow to run over the path. The Perimeter Wire
can be laid under the pavement blocks or in the joint
between them.
Important! The mower must never run over gravel,
mulch, or similar material, which can cause the
mower to slip and damage the blade.
IMPORTANT INFORMATION
If the working area is adjacent to a swimming
pool, watercourse, slope greater than 10%,
precipice higher than 50cm or a public road,
the Perimeter Wire must be supplemented
with a fence or the like. The height must then
be at least 15 cm (6 inches). This will prevent
the mower from ending up outside the working
area under any circumstances.
Min 1.2m ( 4ft )
Min 1.2m ( 4ft )
If such a barrier exists, you may set the
Perimeter Wire 28 cm (11 inches) from the
barrier.
If there is no fence or the like, then lay the
Perimeter Wire at minimum distance of 1.2m
from the water.
Min 15cm (6”)
6’’ )
Perimiter Perimeter Wire 28cm 28cm (11”) (11’’ )
o
Maintain a 45° angle in all left-turn corners when
laying the wire along the perimeter. It is not necessary
to maintain 45° angle on right-turn corners along the
perimeter.
90 o
Right turns
o
Continue laying the wire, according to your plan.
Gradually pull the wire out of its dispenser and lay it
loosely as you are moving in an anticlockwise direction.
45 o
20cm
Left turns
18