MERIDIAN SYSTEM REMOTE (MSR+) User Guide - Meridian Audio
MERIDIAN SYSTEM REMOTE (MSR+) User Guide - Meridian Audio
MERIDIAN SYSTEM REMOTE (MSR+) User Guide - Meridian Audio
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Programming Programming options<br />
6<br />
Specifying a device code<br />
The simplest way to set up the <strong>MSR+</strong> to control another product<br />
is to enter the appropriate device code for the product. A complete<br />
list of device codes for each of the supported products is given at<br />
the back of this manual.<br />
Entering a device code erases any learnt commands for that source<br />
key.<br />
To specify a device code<br />
• Press the source key you want to use for the product; for<br />
example, TAPE.<br />
• Hold down 0 and Mute simultaneously for two seconds until the<br />
indicator flashes twice and stays lit.<br />
• Enter the appropriate device code on the numeric keypad.<br />
For example, if your tape deck is a Revox enter 0664.<br />
If you entered a valid device code the indicator will turn off and<br />
your <strong>MSR+</strong> is ready to control the other product. If you entered an<br />
incorrect code, or pressed an invalid key, the indicator will flash six<br />
times and programming is abandoned.<br />
For some products more than one device code is listed. Try each<br />
of the alternative device codes in turn until you find the one that<br />
controls your product.<br />
To reset the source key to control <strong>Meridian</strong> products enter the<br />
device code 8888.<br />
Auto-programming<br />
This procedure lets you step through the library of remote controls<br />
in the <strong>MSR+</strong> until you find the one that switches your product to<br />
standby. This is likely to be the correct one for your product.<br />
To auto-program<br />
• Make sure your other product is switched on and out of standby.<br />
• Press the source key you want to use for the product; for example<br />
TV.<br />
• Hold down 0 and Mute simultaneously until the indicator flashes<br />
twice and then stays lit.<br />
G Series MSR 6<br />
7/7/03, 3:16:27 pm