Applications Guide Tracer Graphical Programming - Trane

®
Adding an Output block
Figure 21: Greater Than block in program
Greater
Than block
Adding an Output block
To apply the output of the Greater Than block to actually control the fan,
add an Output block to the program to pass data to the Equip Rm Fan
On/Off binary output. Output blocks pass data out of the program, controlling
analog and binary hardware outputs.
To add an Output block:
1. From the Blocks menu, choose Input/Output. From the Input/Output
menu, choose Output (Hardware).
2. Click in the design space to place the Output (Hardware) block
(Figure 22).
Figure 22: Output (Hardware) block in design space
Output (Hardware) block
3. Set the properties so that the type is binary and the designated output
is Equip Rm Fan On/Off (Figure 23).
Figure 23: Equip Rm Fan On/Off output block
CNT-APG001-EN 23