Applications Guide Tracer Graphical Programming - Trane

®
Programming best practices
Table 32: Grouping programming tasks into programs (continued)
Program name
DischargeAirControl
Alarms
Control functions
Discharge air setpoint calculation
Cooling valve control
Heating valve control
Dehumidification
Humidification
Alarm management
Construct your own TGP library and reuse programs
As you program jobs, keep the program files (*.tgp) and the accompanying
Rover configuration (*.rcf) files for the jobs. When you program another
job that is similar, you can reuse both the configuration files and the programs
from your library. You may need to modify the programs to accommodate
differences in the sequences of operation, but reusing programs is
much more efficient than writing them from scratch.
For more information about wiring, configuring, and programming the
Tracer MP580/581 controller, see the following:
• Tracer MP581 Programmable Controller Hardware Installation guide
(CNT-SVN01A-EN)
• Tracer MP580/581 Programmable Controller Programming guide
(CNT-SVP01A-EN)
• Online Help in the Rover service tool and the TGP editor
• PID Control in Tracer Controllers applications guide
(CNT-APG002-EN)
CNT-APG001-EN 233