28.09.2014 Views

DRIVER'S MANUAL SB220GS - Training Registration System

DRIVER'S MANUAL SB220GS - Training Registration System

DRIVER'S MANUAL SB220GS - Training Registration System

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

TOWING<br />

- Move the steering lock/contact-starter<br />

key of the towed vehicle to the position<br />

in which the steering wheel is unlocked<br />

(unless the vehicle is being towed with<br />

its wheels hoisted clear of the road; also<br />

see below).<br />

- Always use a towing bar. Departure from<br />

this rule is only allowed in emergency<br />

situations; in that case the maximum<br />

permissible towing speed in 40 km/h.<br />

- To prevent possible damage to the<br />

gearbox, the propeller shaft should be<br />

disconnected at the differential.<br />

- To prevent possible damage to the<br />

chassis, the angle at which the vehicle<br />

is towed may not exceed 30° in relation<br />

to the road surface.<br />

- Release the parking brake if the air reservoir<br />

pressure is insufficient (see also<br />

“Releasing the parking brake”).<br />

If the differential is damaged:<br />

- Hoist the vehicle at the rear end and<br />

engage the steering wheel lock.<br />

Tow-starts<br />

It is not possible to start the engine of a<br />

vehicle equipped with an automatic<br />

gearbox by using the tow-start method.<br />

REPLACING BULBS<br />

- Before attempting to replace any bulbs<br />

on the vehicle, refer to the chassis builder’s<br />

instructions (if supplied). This<br />

applies to the interior and exterior lights<br />

of the vehicle as well as to adjustment<br />

of the headlights.<br />

- When fitting a new bulb, make sure that<br />

the ridges on the bulb holder fit in the<br />

recesses in the reflector.<br />

- Never touch the glass of a halogen bulb<br />

with your bare fingers.<br />

1<br />

00799B<br />

Tachograph<br />

- Rotate lamp holder (1) a quarter turn,<br />

remove, and replace the bulb.<br />

1<br />

66<br />

MAINTENANCE

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!