DRIVER'S MANUAL SB220GS - Training Registration System
DRIVER'S MANUAL SB220GS - Training Registration System
DRIVER'S MANUAL SB220GS - Training Registration System
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
3 - position for hilly routes:<br />
1st, 2nd and 3rd gears are changed up and<br />
down depending on the engine load and the<br />
driving speed.<br />
Kick-down<br />
A kick-down switch is fitted under the<br />
accelerator pedal. When fast acceleration<br />
is required, the accelerator pedal should be<br />
pushed down to its full extent. Depending<br />
upon the road speed, this will cause the<br />
gearbox to change down automatically to a<br />
lower forward speed.<br />
Changing up to the next gear will only occur<br />
once the maximum engine speed allowed<br />
has been reached.<br />
Starting<br />
The engine can only be started when<br />
position N is engaged.<br />
Operate the parking brake before starting.<br />
ZF Automatic gearbox:<br />
At temperatures below - 15°C start the<br />
engine and run the engine warm in position<br />
N for about 10 minutes at 1000 rpm before<br />
driving away.<br />
Driving away from rest<br />
With the vehicle stationary, the brakes<br />
applied and the engine idling, select the<br />
desired position (D = forward speed, or R =<br />
reverse), then wait for 1-2 seconds, release<br />
the brakes, depress the accelerator pedal<br />
and drive away.<br />
Do not accelerate whilst switching on and<br />
stationary.<br />
Note<br />
To prevent the bus from rolling backwards<br />
whilst on a slope, the accelerator should be<br />
depressed before the brake pedal/parking<br />
brake is released.<br />
Special note!<br />
If the vehicle does not drive away or the<br />
wrong option is selected:<br />
- Remove the foot from the accelerator;<br />
- Press the “N” key and then the desired<br />
option key.<br />
Should you unintentionally engage position<br />
N whilst the vehicle is in motion, you must<br />
again select position D in order to prevent<br />
damage to the drive line. The electronically<br />
controlled gear selector unit will then<br />
automatically select the forward speed that<br />
matches the road speed.<br />
Stopping<br />
The vehicle can always be brought to a stop<br />
regardless of the chosen gear.<br />
The electronic automatic gear always changes<br />
to 1st gear after stopping (depending<br />
on any fitted options such as Neutral at<br />
Stationary (NBS, EK-ab) etc.). Whilst stopping<br />
for a short period of time, for example<br />
at a traffic light, the gearbox can remain in<br />
option “D” or in the chosen gear. The engine<br />
may then only idle.<br />
Driving in reverse<br />
Change from “D” to “R” or vice versa:<br />
- Bring the vehicle to a stop and keep the<br />
brake pedal depressed;<br />
- Idle the engine;<br />
- Push in the neutral switch “N”.<br />
If the vehicle is equipped with a switch<br />
(39), then this switch should also be<br />
operated.<br />
- Select the required option.<br />
DRIVING<br />
41