DRIVER'S MANUAL SB220GS - Training Registration System
DRIVER'S MANUAL SB220GS - Training Registration System
DRIVER'S MANUAL SB220GS - Training Registration System
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
17. ASR WARNING LAMP*<br />
The anti-spin regulator (ASR) prevents the<br />
wheels from spinning when pulling away and<br />
on slippery road surfaces. When the wheels<br />
spin, the driven wheels are slowed down<br />
and/or the fuel supply is reduced depending<br />
on the driving situation. ASR is a fully<br />
automatic system integrated with the ABS<br />
system and engine control unit. There is no<br />
actuator or interrupter for the ASR system.<br />
The instrument panel contains an ASR lamp<br />
to check the ASR installation.<br />
This lamp will light up when:<br />
- Contact is switched on. If the installation<br />
functions correctly, the lamp should go<br />
off.<br />
The lamp remains “off”, even if the<br />
vehicle is stopped with the engine<br />
running. The lamp will only come on<br />
again and the switched on if contact is<br />
switched off for at least 20 seconds.<br />
- The ASR installation is started.<br />
- Max. speed is exceeded (Wabco speed<br />
limiter) or if there is a malfunction present<br />
in the speed limiter system.<br />
- ASR defect:<br />
The ASR installation is defective when<br />
the red warning lamp lights up while<br />
vehicle speed is over 7 km/h and the<br />
ASR installation is not working. In this<br />
case, the fuses in the Central E-panel<br />
should be checked.<br />
If the defect cannot be resolved by<br />
changing a fuse, you<br />
can still drive on.<br />
Have the defect repaired at a DAF BUS<br />
Dealer.<br />
18. CENTRAL LUBRICATION<br />
WARNING LAMP<br />
This lamp will light up when the central<br />
lubrication system is started. In case of a<br />
fault in the central lubrication system, the<br />
lamp will remain on.<br />
19. REAR FOG LIGHT WARNING<br />
LAMP<br />
This lamp will light up when the rear fog<br />
lights are switched on.<br />
20. START SWITCH*<br />
The engine can be started using this switch.<br />
Also see "DRIVING”.<br />
21. HAZARD WARNING LIGHTS SWITCH<br />
Pushing in this switch causes all the<br />
direction indicators to flash simultaneously.<br />
The hazard warning lights are switched off<br />
by pushing in the switch again. The warning<br />
lamp in the switch indicates that the hazard<br />
warning lights are in operation.<br />
23. PREGLOW SWITCH<br />
With the contact switched on, this switch<br />
will operate the preheating system. Also see<br />
“DRIVING”.<br />
24. REAR FOG LIGHT SWITCH<br />
The rear fog lights can be switched on using<br />
this switch when the vehicle lighting switch<br />
is in position II or when the front fog lights<br />
are already switched on.<br />
The warning lamp in the switch and the<br />
warning lamp (19) light up when the fog<br />
lights are switched on.<br />
Note:<br />
The legal regulations for the use of fog lights<br />
differ from country to country.<br />
25. FUEL GAUGE<br />
The fuel gauge only operates when the contact<br />
is on.<br />
22<br />
INSTRUMENTS AND CONTROLS