DRIVER'S MANUAL SB220GS - Training Registration System
DRIVER'S MANUAL SB220GS - Training Registration System
DRIVER'S MANUAL SB220GS - Training Registration System
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
CLEANING<br />
Cleaning the vehicle.<br />
When using a high-pressure cleaning device<br />
is used, note the following:<br />
- Make sure all doors, windows and roof<br />
hatchets are closed.<br />
- Do not aim directly at the seals. They<br />
may be blown open, causing the<br />
lubricant behind them to be washed<br />
away. This may happen to the swivel joint<br />
of the steering house, for instance.<br />
The swivel joint’s cross piece will then<br />
get stuck, which results in “sticky” steering.<br />
- Water may enter the steering oil reservoir<br />
through the bleeder.<br />
This damages the steering gear.<br />
- When cleaning the radiator/intercooler,<br />
make sure that the fins are not<br />
damaged.<br />
- Do not aim the beam at the air<br />
conditioning system’s condenser for a<br />
prolonged period of time. The rise in<br />
temperature will cause the pressure in<br />
the system to become too high. This has<br />
a damaging effect.<br />
- Make sure no water enters the<br />
differential and gearbox through the<br />
bleeders.<br />
- Make sure no water enters the clutch,<br />
brakes, etc. through the reservoir bleeder.<br />
- The engine and engine compartment<br />
may be cleaned with a high-pressure<br />
cleaning device. Do not aim directly at<br />
electric components such as starter<br />
motor, alternator, etc.<br />
- Carefully clean the engine encapsulation<br />
and encapsulation parts. Make sure that<br />
spoilt oil is removed (fire hazard).<br />
- Do not aim the high-pressure cleaning<br />
device’s beam at electric connections<br />
like connectors, lighting wires, etc.<br />
- Make sure no water enters the air inlet<br />
system through the air inlet or its flexible<br />
seals.<br />
- Make sure no water enters via the oil<br />
dipstick.<br />
- After cleaning, the vehicle has to be<br />
lubricated by means of a grease gun or<br />
by means of the central lubrication<br />
system. This helps to keep moisture and<br />
dirt from entering the various pivots.<br />
Note<br />
Before cleaning the vehicle, check if there<br />
are any leakages in the engine, axles,<br />
gearbox, etc. It is not possible to do this after<br />
cleaning the vehicle, during maintenance<br />
activities.<br />
10<br />
IMPORTANT INSTRUCTIONS