Favor ins_manual.fh11

REPLACING ANTI-CAL CARTRIDGE
1. The “Change Anti-Cal” indicator
blinking.
2. Keep your steam generator remain ON
mode.
3. Slide out the water tank.
4. Slide out the anti-cal cartridge container
and replace anti-cal cartridge.
5. Wait for 5 seconds after Step 4 to
reinstall the anti-cal cartridge container.
6. Reinstall the water tank.
DRAINING THE WATER
1. Disconnect the power cord from mains
supply outlet.
2. Slide out the water tank.
3. Empty the water in the tank holding on
it upside down as fig.6.
4. Reinstall the water tank.
Note:
1. Anti-cal cartridge cannot be removed
unless water tank is slide out.
2. If the anti-cal cartridge container is not
properly install, a continuous a “beep”
sound will hear when press steam
button.
3. If anti-cal cartridge is replaced during
OFF mode, the anti-cal electronic
system will not recognize a new
cartridge has been change.
Important:
1. Please do not attempt to use the
exhausted anti-cal cartridge. This will
cause damage to the appliance and
the electronic system.
2. Please do not left the anti-cal cartridge
container empty. This will cause
damage to the appliance and the
electronic system.
SELF CLEAN
Your Electronic Steam Generator has
a built in cleaning system designed to
keep the steam vents and steam
chamber clear of lint and loose mineral
material. Suggest doing once a month.
1. Unwind and straighten the power cord
and supply cord.
2. Fill the water tank with tap water. (See
How to fill water)
3. Connect the appliance to a suitable
mains supply outlet.
4. Ensure “Steam Level” indicators in MAX
position.
5. Ensure the temperature dial on the iron
in MIN position.
6. The appliance is ready for self-clean.
7. Hold the iron about 6”(150mm) above
the sink in the ironing position, presses
and hold the steam Button to about 3
minutes. Loose material will come out
through the steam holes of the iron
15