Air hydrAulic pump - Harbor Freight Tools

SPECIFIC SAFETY RULES
1.
2.
3.
4.
5.
6.
7.
8.
9.
Do not adjust the factory set Safety Valve. This valve should only be set, or reset
by a qualified technician.
This air hydraulic pump must be secured tightly to a secure and stable surface
to prevent dynamic pressure from moving it around as you work. Make
sure it is not a tripping hazard.
Follow all manufacturer’s instructions for the air compressor and all attachments
you are using.
Maintain a safe working environment. Make sure there is adequate surrounding
workspace. Do not use this product in a damp or wet location.
The brass components of this product contain lead, a chemical known to the
State of California to cause birth defects (or other reproductive harm). (California
Health & Safety Code § 25249.5, et seq.)
NEVER press the end of the hose against your skin or the skin of another
person or animal. It is possible to inject fluids into your skin using this tool inappropriately.
Hydraulic components must be opened and serviced only by a qualified
technician.
Use clean, dry, and regulated compressed air. Do not exceed the recommended
110-120 PSI. Never use oxygen, carbon dioxide, combustible gases, or any other
bottled gas as a power source for this tool.
Maintain labels and nameplates on the tool. These carry important information.
If unreadable or missing, contact Harbor Freight Tools for a replacement.
Unpacking
When unpacking, check to make sure that the item is intact and undamaged. If any
parts are missing or broken, please call Harbor Freight Tools at the number shown on the
cover of this manual as soon as possible.
SKU 95945 For technical questions, please call 1-800-444-3353.
Page