caution - Toro

Wing Deck Latch
Disassembly (Fig. 12)
1. Raise wing deck to transport position. Carefully rotate
latch to closed position.
9
13
2. Loosen lug nut to release compression spring tension.
3. Remove retaining ring and flat washer from bottom
of latch pin. Rotate lug nut enough to allow latch pin to
be removed from latch.
14
4. Remove lug nut from spring support. Remove latch
assembly from deck.
5. Disassemble latch (items 1 through 8) using Figure
12 as a guide.
3
4
2
5
6
3
4
12
Assembly (Fig. 12)
1. Assemble latch (items 1 through 8) using Figure 12
as a guide.
1
5
10
9
8
4
7
11
2. Slide spring onto spring support and insert end of
spring support into hole located on underside of center
deck. Start lug nut (tapered side towards plate on deck)
onto spring support.
3. Tighten lug nut until holes in front of deck align with
bushings in latch. Insert latch pin with retaining ring
down through deck and latch. Secure latch pin on underside
of deck with flat washer and retaining ring.
1. Latch
2. Grease fitting
3. Lock roller
4. Bushing
5. Flange bushing
6. Cap screw (3 used)
7. Spring support
Figure 12
8. Lock nut (3 used)
9. Retaining ring
10. Flat washer
11. Compression spring
12. Lug nut
13. Latch pin
14. Center deck
4. Carefully rotate latch to the open position. Lower
wing deck to allow link to engage latch.
5. Lubricate latch grease fitting.
Cutting Deck Page 8 - 14
Groundsmaster 4100--D