caution - Toro

Disassembly (Fig. 1)
1. Park machine on a level surface, lower cutting deck,
stop engine, engage parking brake and remove key
from the ignition switch.
2. Disassemble steering tower as needed using Figure
1 as a guide.
Assembly (Fig. 1)
1. Assemble steering tower using Figure 1 as a guide.
A. Thrust washer(s) (item 24) on steering column
are used as needed to remove end play of steering
shaft.
B. If steering wheel was removed, torque hex nut
(item 1) from 16 to 20 ft lb (22 to 27 N -m).
Chassis
Groundsmaster 4100--D Page 7 - 3 Chassis