caution - Toro

Bevel Gear Case and Axle Case
The following procedures assume the rear axle assembly
has been removed from the machine (see Rear Axle
Assembly Removal in this section).
35 to 41 ft -lb
(47to56N-m)
Bevel Gear Case and Axle Case Removal
1
6
5
1. Remove the mounting screws, nuts and lock washers.
Remove the bevel gear case/axle case assembly
and O-ring from the axle support (Fig. 15).
2. Mark both right and left bevel gear case/axle case
assemblies.
IMPORTANT: Do not interchange right and left bevel
gear case/axle case assemblies.
4
2
35 to 41 ft -lb
(47to56N-m)
1. Cap screw (4 used)
2. Lock nut (2 used)
3. Lock washer (2 used)
4. Axle support
3
Figure 15
5. Bevel gear case/axle
case assembly
6. O-ring
3. Remove the axle cover mounting screws. Remove
the axle cover from the axle case as an assembly
(Fig. 16).
17 to 20 ft -lb
(23to27N-m)
1
4
3
1. Axle case
2. Axle cover assembly
2
Figure 16
3. Mounting screw (6 used)
4. O-ring
Axles, Planetaries
and Brakes
4. Remove the axle case support mounting screws, the
axle case support and the support shims (Fig. 17).
Threadlocking
Compound
3
2
4
57 to 67 ft -lb
(77to91N-m)
1
1. Axle case
2. Axle case support
Figure 17
3. Mounting screw (2 used)
4. Support shim
Groundsmaster 4100--D Page 6 - 17 Axles, Planetaries and Brakes