caution - Toro

Transport / 4WD Switch
The transport/4WD switch is used to set the machine
traction speed for transport or mow. The transport/4WD
rocker switch is located on the control console next to
the operator seat (Fig. 21).
1
Testing
The switch terminals are shown in Figure 22. The circuitry
of the switches is shown in the chart below. With the
use of a multimeter (ohms setting), the switch functions
may be tested to determine whether continuity exists
between the various terminals for each position. Verify
continuity between switch terminals.
SWITCH
POSITION
NORMAL
CIRCUITS
OTHER
CIRCUITS
TRANSPORT 2+3 5+6
MOW 1+2 4+5
Figure 21
1. Control console 2. Transport/4WD switch
2
4 5 6
1 2 3
BACK OF TRANSPORT / 4WD SWITCH
Figure 22
Electrical
System
Groundsmaster 4100--D Page 5 - 15 Electrical System