Multi Pro 5700 - Toro

Radiator
10
9
8
8
7
4
3
6
5
4
3
1
16
15
14
13
12
2
FRONT
RIGHT
17
18
4
11
19
20
22
24
18
13
23
21
20
25
26
1. Oil cooler
2. Radiator brace (2 used)
3. Flat washer
4. Lock washer
5. Cap screw (2 used)
6. Cap screw (4 used)
7. Overflow hose
8. Hose clamp
9. Overflow bottle
Figure 7
10. Hose
11. Radiator shroud
12. Foam seal (2 used)
13. Foam seal
14. Radiator
15. Hose clamp
16. Upper radiator hose
17. Lower radiator hose
18. Flat washer
19. Cap screw (4 used)
20. Fan shroud
21. Flange nut
22. Cap screw (2 used)
23. Foam seal (2 used)
24. Foam seal (2 used)
25. Isomount (2 used)
26. Flange nut (2 used)
Removal (Figs. 7)
1. Park machine on a level surface, stop engine, engage
parking brake and remove key from the ignition
switch. Raise seats of machine to allow access to engine
compartment.
CAUTION
Do not open radiator cap or drain coolant if the
radiator or engine is hot. Pressurized, hot coolant
can escape and cause burns. Ethylene–glycol
antifreeze is poisonous. Dispose of coolant
properly, or store it in a properly labeled container
away from children and pets.
2. Drain radiator into a suitable container using the radiator
drain (see Operator’s Manual).
3. Loosen hose clamps that secure radiator hoses. Disconnect
upper and lower hoses from the radiator.
4. Loosen hose clamp that secures overflow hose to radiator
flange (Fig. 9). Slide overflow hose from radiator
flange and position hose away from radiator.
5. Remove six (6) cap screws (items 5 and 6), lock
washers and flat washers that secure top and bottom of
radiator shroud to radiator.
Kubota Diesel Engine
Page 3 – 10
Multi Pro 5700–D