Multi Pro 5700 - Toro

Installation (Fig. 6 or 7)
1. Install all removed heat shields, hangers and brackets
to exhaust components.
2. Make sure that gasket surfaces on engine exhaust
manifold and exhaust pipe are clean.
NOTE: On machines with serial number below
310000000, the muffler inlet is offset and the muffler outlet
is centered.
3. Install all removed exhaust system components using
Fig. 6 (machines with serial number below
310000000) or Fig. 7 (machines with serial number
above 310000000) as a guide.
A. During exhaust installation, finger tighten all exhaust
system components before fully tightening
any of the fasteners.
B. Install rubber exhaust system hangers as noted
during exhaust system removal.
C. Make sure that tailpipe outlet is parallel to the
ground.
D. Tighten muffler clamps last to secure exhaust
components.
SERIAL NUMBER ABOVE 310000000
13
1. Muffler gasket
2. Lock washer (4 used)
3. Cap screw (4 used)
4. Exhaust pipe
5. Screw (2 used)
6. Flat washer (3 used)
7. Muffler hanger (3 used)
3
2
5
6
7
8 9
6
7
4
14
10
1
Figure 7
11
12
8. Flange nut (2 used)
9. Cap screw (2 used)
10. Muffler hanger (2 used)
11. Muffler clamp (2 used)
12. Muffler
13. Flange nut
14. Carriage screw
7
Kubota Diesel
Engine
Rev. D
Multi Pro 5700--D Page 3 - 9 Kubota Diesel Engine