Multi Pro 5700 - Toro

Diagnostic Display
Inputs
AUTO MODE
L RAISE
LLOWER
R RAISE
RLOWER
LNOSNSRDATA
L NOT TRACKING
RNOSNSRDATA
R NOT TRACKING
L -- SNSR FEEDBACK
R -- SNSR FEEDBACK
Diagnostic Display
LED Operation
Sonic mode switch in auto position: LED ON
Sonic mode switch not in auto position: LED OFF
Left boom actuator switch in raise position: LED ON
Left boom actuator switch not in raise position: LED OFF
Left boom actuator switch in lower position: LED ON
Left boom actuator switch not in lower position: LED OFF
Right boom actuator switch in raise position: LED ON
Right boom actuator switch not in raise position: LED OFF
Right boom actuator switch in lower position: LED ON
Right boom actuator switch not in lower position: LED OFF
ECU has detected an invalid reading from left sensor: LED ON
Left sensor operating normally: LED OFF
Left boom not tracking to target within 5 seconds: LED ON
Left sensor operating normally: LED OFF
ECU has detected an invalid reading from right sensor: LED ON
Right sensor operating normally: LED OFF
Right boom not tracking to target within 5 seconds: LED ON
Right sensor operating normally: LED OFF
ECU receiving signal from left sensor: LED ON
ECU not receiving signal from left sensor: LED OFF
ECU receiving signal from right sensor: LED ON
ECU not receiving signal from right sensor: LED OFF
NOTE: When the vehicle ignition switch is in the OFF
position, all Diagnostic Display LED’s should be OFF.
NOTE: Initial calibration of the Sonic Boom sensors is
required for proper operation of ECU inputs. Refer to
your Sonic Boom Kit Installation Instructions for information
on initial sensor calibration.
NOTE: Right and left side Sonic Boom sensors are
identical so they can be exchanged to assist in troubleshooting.
If a problem follows the exchanged sensor, an
electrical problem likely exists with the sensor. If the
problem remains unchanged, something other than the
sensor is the problem source (e.g. switch, circuit wiring).
Sonic Boom System (Optional Kit)
Page 7.1 - 18
Multi Pro 5700--D