Multi Pro 5700 - Toro

Removal (Fig. 48)
1. Park machine on a level surface, place spray booms
in the transport (raised) position, stop engine, engage
parking brake and remove key from the ignition switch.
2. Disconnect boom actuator from machine wire harness.
3. Remove pivot pin (item 8) that secures actuator to
clevis strap (item 9) on boom frame.
4. Remove cotter pin (item 11) from clevis pin (item 12).
Support boom actuator and slide clevis pin from boom
pivot bracket. Remove actuator from machine.
Installation (Fig. 48)
1. Position boom actuator to boom frame and boom
pivot bracket.
2. Secure actuator to boom pivot bracket with clevis pin
and cotter pin.
3. Secure actuator to clevis strap on boom frame with
pivot pin.
4. Connect boom actuator to machine wire harness.
Spray
System
Multi Pro 5700–D Page 6 – 47 Rev. A Spray System